Mining activities may cause severe ground subsidence, endangering surface structures and farmlands. Therefore, the acquisition of spatial-temporal evolution of the mining goaf is of great significance. Hotspot analysis (HSA) based on the Getis-Ord G $_{i}^*$ statistics has been utilized to identify the areas with a rapid deformation rate. In this paper, we propose an improved HSA (IHSA) method for automatic extraction of the surface subsidence caused by the mining goaf. Additionally, we design a comprehensive workflow for the automatic spatial-temporal evolution inversion of surface deformation induced by the mining goaf. Firstly, time series interferometric synthetic aperture radar (TS-InSAR) is utilized to generate the surface deformation of the mining area. Then, the IHSA method is used for the automatic identification of the mining goaf. Finally, the total least-squares probability integral method (TLS-PIM) is applied for goaf inversion based on the extracted deformation information. For this study, the Wuxiang is selected as the study area. We have compared the IHSA method with four methods using five indicators, and likewise, we have compared the TLS-PIM method with four methods in terms of their correlation with the InSAR results in the strike and dip directions. The experimental results demonstrate the superiority of our method as a support for the geological hazard investigation and mine safety supervision department.
Slow-moving landslides often occur in areas of high relief, which are significantly affected by tropospheric delay. In general, tropospheric delay correction methods in the synthetic-aperture radar interferometry (InSAR) field can be broadly divided into those based on external auxiliary information and those based on traditional empirical models. External auxiliary information is hindered by the low spatial–temporal resolution. Traditional empirical models can be adaptable for the spatial heterogeneity of tropospheric delay, but are limited by preset window sizes and models. In this regard, this paper proposes an improved tropospheric delay correction method based on the multivariable move-window variation model (MMVM) to adaptively determine the window size and the empirical model. Considering topography and surface deformation, the MMVM uses multivariate variogram models with iterative weight to determine the window size and model, and uses the Levenberg–Marquardt (LM) algorithm to enhance convergence speed and robustness. The high-precision surface deformation is then derived. Combined with hotspot analysis (HSA), wide-area potential landslides can be automatically identified. The reservoir area of the Baihetan hydropower station in the lower reaches of the Jinsha River was selected as the study area, using 118 Sentinel-1A images to compare with four methods in three aspects: corrected interferograms, derived deformation rate, and stability of time-series deformation. In terms of mean standard deviation, the MMVM achieved the lowest value for the unwrapped phase in the non-deformed areas, representing a reduction of 56.4% compared to the original value. Finally, 32 landslides were identified, 16 of which posed a threat to nearby villages. The experimental results demonstrate the superiority of the proposed method and provide support to disaster investigation departments.
Landslide susceptibility algorithms demonstrate high reliability in quantifying the likelihood of landslide occurrence. However, traditional methods are often limited by computationally intensive sampling strategies and models with limited adaptability. In this study, we propose an adaptive sampling strategy based on hotspot analysis to enhance the reliability of the generated samples. Additionally, we develop an improved meta-ensemble (IME) stacking-based heterogeneous framework for landslide susceptibility assessment by integrating a support vector machine (SVM), random forest (RF), and XGBoost. To further reduce factor complexity, a Monte Carlo-based frequency ratio analysis is employed. The Baihetan Reservoir area along the Jinsha River was selected as the study area. A total of 26 conditioning factors were considered, supplemented by 120 Sentinel-1A images to cover the study area. The proposed sampling strategy was then used to generate high-quality samples. Finally, to evaluate the performance of the proposed method, the proposed ensemble learning framework was applied to assess landslide susceptibility with eight models using five evaluation metrics. The experimental results demonstrated that: (1) the adaptive sampling strategy improved both the quantity and quality of the training samples; (2) the adoption of the Monte Carlo strategy increased the sample partitioning rate; and (3) despite the formally highest IME metrics, the inclusion of InSAR information did not lead to a statistically significant improvement in the forecast compared to the high-quality basic sampling strategy. Overall, the proposed methodology provides valuable support for regional geohazard susceptibility assessment in dynamic environments.