Mining activities may cause severe ground subsidence, endangering surface structures and farmlands. Therefore, the acquisition of spatial-temporal evolution of the mining goaf is of great significance. Hotspot analysis (HSA) based on the Getis-Ord G $_{i}^*$ statistics has been utilized to identify the areas with a rapid deformation rate. In this paper, we propose an improved HSA (IHSA) method for automatic extraction of the surface subsidence caused by the mining goaf. Additionally, we design a comprehensive workflow for the automatic spatial-temporal evolution inversion of surface deformation induced by the mining goaf. Firstly, time series interferometric synthetic aperture radar (TS-InSAR) is utilized to generate the surface deformation of the mining area. Then, the IHSA method is used for the automatic identification of the mining goaf. Finally, the total least-squares probability integral method (TLS-PIM) is applied for goaf inversion based on the extracted deformation information. For this study, the Wuxiang is selected as the study area. We have compared the IHSA method with four methods using five indicators, and likewise, we have compared the TLS-PIM method with four methods in terms of their correlation with the InSAR results in the strike and dip directions. The experimental results demonstrate the superiority of our method as a support for the geological hazard investigation and mine safety supervision department.
Slow-moving landslides often occur in areas of high relief, which are significantly affected by tropospheric delay. In general, tropospheric delay correction methods in the synthetic-aperture radar interferometry (InSAR) field can be broadly divided into those based on external auxiliary information and those based on traditional empirical models. External auxiliary information is hindered by the low spatial–temporal resolution. Traditional empirical models can be adaptable for the spatial heterogeneity of tropospheric delay, but are limited by preset window sizes and models. In this regard, this paper proposes an improved tropospheric delay correction method based on the multivariable move-window variation model (MMVM) to adaptively determine the window size and the empirical model. Considering topography and surface deformation, the MMVM uses multivariate variogram models with iterative weight to determine the window size and model, and uses the Levenberg–Marquardt (LM) algorithm to enhance convergence speed and robustness. The high-precision surface deformation is then derived. Combined with hotspot analysis (HSA), wide-area potential landslides can be automatically identified. The reservoir area of the Baihetan hydropower station in the lower reaches of the Jinsha River was selected as the study area, using 118 Sentinel-1A images to compare with four methods in three aspects: corrected interferograms, derived deformation rate, and stability of time-series deformation. In terms of mean standard deviation, the MMVM achieved the lowest value for the unwrapped phase in the non-deformed areas, representing a reduction of 56.4% compared to the original value. Finally, 32 landslides were identified, 16 of which posed a threat to nearby villages. The experimental results demonstrate the superiority of the proposed method and provide support to disaster investigation departments.
Ground deformation is a major geohazard in many urban areas, requiring reliable monitoring and forecasting for hazard mitigation. Although Multi-Temporal InSAR enables high-resolution deformation monitoring, most prediction approaches rely on single-point modeling and fail to exploit spatial dependencies within deformation fields. This study proposes a spatiotemporally synchronous prediction framework for large-scale InSAR deformation fields, integrating sequence preprocessing, spatiotemporal modeling, and deformation pattern analysis. First-order differencing reduces sequence non-stationarity, while a patch-based encoder-decoder structure preserves spatial topology during dimensionality reduction. The core prediction model, built on PredRNNv2, captures the long-term spatiotemporal evolution of InSAR deformation sequences. In addition, independent component analysis (ICA) combined with K-means clustering identifies dominant deformation patterns and their geological associations. The framework is evaluated using synthetic datasets simulating multiple deformation mechanisms and Sentinel-1 InSAR time-series data over the Beijing Plain from 2015 to 2025. Results show that the model accurately captures deformation evolution and identifies transitions associated with groundwater regulation. These findings demonstrate the potential of deep spatiotemporal learning for large-scale InSAR deformation prediction and geohazard mechanism interpretation.