The present study shows porous activated carbon obtained from Chenopodium quinoa Willd and Quillaja saponaria and their use as potential adsorbents to remove three types of dyes from aqueous solutions. The adsorption results were compared with commercial charcoal to check their efficiency. All porous carbon materials were activated using carbon dioxide and steam and fully characterized. Moreover, the steam-activated samples exhibited a high total pore volume with a BET surface area of around 800 m² g⁻¹. Batch adsorption experiments showed that commercial charcoal is the charcoal that offered the best adsorption efficiency for tartrazine and sunset yellow FCF. However, in the case of crystal violet, all activated carbons obtained from Chenopodium quinoa Willd and Quillaja saponaria showed the best captures, outperforming commercial charcoal. Molecular dockings of the dyes on the commercial charcoal surface were performed using AutoDock Vina. The kinetic results of the three isotherm’s models for the present data follow the order: Langmuir~Freundlich > Temkin.

Trichoderma spp. are filamentous fungi generally observed in nature, which are widely marketed as biocontrol agents. The secondary metabolites produced have obtained special attention since they possess attractive chemical structures with a broad spectrum of biological activities. In Cuba, the species of Trichoderma have been commercially applied for the control of several phytopathogens to protect agricultural crops, but few studies have been carried out to detect and characterize the production of metabolites with biological activity. The strain Trichoderma harzianum LBAT-53 was subjected to an antifungal in vitro assay against Fusarium oxysporum f.sp. cubense by dual culture and volatile metabolite assays and fermented in PDB under constant agitation conditions. The ethyl acetate crude extract was obtained by liquid–liquid extraction. The fungal extract was investigated for the composition of secondary metabolites through chemical screening and ultrahigh performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS) in negative ionization mode. As a result, LBAT-53 showed antagonistic activity in vitro (Class 2) against the pathogen evaluated in direct confrontation (76.9% of inhibition in 10 days) and by volatile metabolites (<40% in 7 days). Furthermore, seven low-molecular-weight phenolic compounds, including chrysophanol, phomarin, endocrocin, and trichophenol A, among others, were identified using UHPLC-ESI-MS/MS. This study is the first work on the characterization of secondary metabolites produced by the commercially applied strain LBAT-53, which is a promising source of bioactive compounds. These results provide a better understanding of the metabolism of this fungus, which is widely used in Cuba as biopesticides in agriculture pest control.

Coffee is one of the most consumed beverages worldwide. Its production generates a large amount of waste, and its use is of vital importance to prevent it from becoming a source of environmental pollution. Cuba is a country with a well-known coffee-growing tradition. Although coffee production has decreased, it is vitally important to use the waste generated in these productions to reduce environmental pollution. To know the possible use or application of coffee waste, it is necessary to know its composition. In this article, three Cuban Arabica coffee wastes (husk, parchment and spent coffee grounds) were characterized using chemical, physical and physicochemical methods. In the characterization of these wastes, SEM and EDX were used to determine their microscopic form and chemical composition. The Chesson–Datta method, ATR and TGA were used to determine whether these materials were lignocellulosic. Ash, pH and density of the waste were determined as characterization methods. The extractive content was determined and a phytochemical screening was performed to determine the groups of the secondary metabolites present.

In this study, the characteristic growth of Cladobotryum virescens on nine culture media was analyzed. The growing behavior of this fungus was dependent on the culture medium. In vitro analysis showed that oat agar was better than other media tested with the highest conidia production. The antifungal activity against Fusarium chlamydosporum and Alternaria brassicicola was evaluated by the Dual Culture method. C. virescens displayed high activity against both pathogens acting through antibiosis and mycoparasitism. This effect was increased by a higher competitiveness of the strain for the substrate. Furthermore, the crude ethyl acetate extract of the culture broth was tested in vitro against Botrytis cinerea and Septoria tritici, as well as the hemibiotrophic oomycete Phytophthora infestans using a microtiter plate assay at different concentrations. The extract showed excellent inhibition even below 5 ppm. According to these results, we concluded that C. virescens can be considered as a potential biological control agent in agriculture. To the best of our knowledge, this is the first study to investigate C. virescens as a biocontrol agent for different diseases caused by five relevant pathogens that affect cereals and vegetables.

The increasing frequency of Sargassum spp. blooms represents a global environmental challenge, impacting coastal ecosystems and requiring sustainable management strategies. This study evaluates the potential of Sargassum spp. extract as an encapsulating material for biological pest control, contributing to marine waste valorization. Pelagic Sargassum spp. collected from the Havana coast was processed to obtain an alginate-rich extract, which was used to encapsulate Beauveria bassiana conidia via ionic gelation. FTIR confirmed characteristic carboxylate absorption bands, indicating structural similarities with commercial alginate, while TGA demonstrated comparable thermal behavior. Beads exhibited consistent dimensions (0.5–3 mm) with irregular post-drying shapes. Encapsulation efficiency yielded a conidial concentration of 1.43 × 10⁸ conidia per mL, ensuring retention within the matrix. Long-term viability was confirmed as conidia remained viable and able to grow after six months, potentially benefiting from extract-derived compounds. These findings highlight the potential of repurposing Sargassum spp. for sustainable agricultural applications, advancing environmentally friendly pest management while addressing the ecological burden of excessive Sargassum accumulation.

Structuring oils using oleogels (OGs) represents a promising strategy for developing semi-solid lipid matrices with applications in food and other soft systems. This study evaluated the thermal stability and physicochemical properties of an oleogel (OG) formulated with extra virgin olive oil (EVOO) and beeswax (BW, 6%). The oleogel and olive oil samples were initially characterized by thermogravimetric analysis (TGA/DTG). The beeswax and oleogel samples were initially characterized by texture analysis. An antioxidant capacity (ORAC) analysis was initially applied to the beeswax sample. An initial rheometric analysis was applied to the oleogel sample. Fatty acid profiling and infrared spectroscopy were applied initially and finally to the oleogel and olive oil samples. During the thermal processing (80 °C, 14 days) of the oleogel and olive oil, analyses of the percentage of polar compounds, refractive index, and absorption parameters (K₂₃₂ and K₂₇₀) were performed. The oleogel exhibited a soft, pseudoplastic network, with lower hardness and mechanical strength than pure beeswax. Gelation modified the thermo-oxidative stability of EVOO, showing lower levels of polar compounds (from day 7 of heating; p = 0.028) and a slight delay in the onset of thermal degradation (Tonset), suggesting partial protection against the formation of polar degradation compounds. Furthermore, the evolution of K₂₃₂ indicated differences in the formation of primary oxidation products (p = 0.027) over the 14 days of heating, while K₂₇₀ showed no differences in the formation of secondary oxidation compounds. This reflects the complex interaction between the gelled matrix and the lipid deterioration mechanisms. Overall, the results demonstrate that the incorporation of beeswax allows for a partial reduction in degradation compounds in high-temperature processes, producing technologically functional oleogels that offer a potential alternative source for structuring solid fats. This work provides relevant evidence for the rational design of oleogels based on unrefined oils and opens new opportunities for their application in food systems and gelled matrices with thermal processing requirements.