We present herein a modified cold sintering process (CSP) for BaTiO3 ceramics using a surface coating at the particle surface which could enhance the relative density of BaTiO3 up to ∼93.5% at 220 °C and 500 MPa. The surface coating greatly enhances the ceramic density, mainly because it facilitates the dissolution–precipitation process during CSP. Ba vacancies form at the surface of the coated powders, so Ba(OH)2 solution is used to compensate Ba ions in the as-cold-sintered ceramics, which increases the dielectric permittivity. Post-annealing at 700 and 900 °C increases the relative density to 97%, and the resulting relative dielectric permittivities are 810 and 1550, respectively, at room temperature and 1 kHz. This technique may also be extended to materials with very small, incongruent solubility in water or volatile solutions that use the cold sintering process.
Experiments and simulation studies on 283 MeV I ion induced single event effects of silicon carbide (SiC) metal–oxide–semiconductor field-effect transistors (MOSFETs) were carried out. When the cumulative irradiation fluence of the SiC MOSFET reached 5 × 106 ion⋅cm−2, the drain–gate channel current increased under 200 V drain voltage, the drain–gate channel current and the drain–source channel current increased under 350 V drain voltage. The device occurred single event burnout under 800 V drain voltage, resulting in a complete loss of breakdown voltage. Combined with emission microscope, scanning electron microscope and focused ion beam analysis, the device with increased drain–gate channel current and drain–source channel current was found to have drain–gate channel current leakage point and local source metal melt, and the device with single event burnout was found to have local melting of its gate, source, epitaxial layer and substrate. Combining with Monte Carlo simulation and TCAD electrothermal simulation, it was found that the initial area of single event burnout might occur at the source–gate corner or the substrate–epitaxial interface, electric field and current density both affected the lattice temperature peak. The excessive lattice temperature during the irradiation process appeared at the local source contact, which led to the drain–source channel damage. And the excessive electric field appeared in the gate oxide layer, resulting in drain–gate channel damage.
The pattern dependence in synergistic effects was studied in a 0.18 μm static random access memory (SRAM) circuit. Experiments were performed under two SEU test environments: 3 MeV protons and heavy ions. Measured results show different trends. In heavy ion SEU test, the degradation in the peripheral circuitry also existed because the measured SEU cross section decreased regardless of the patterns written to the SRAM array. TCAD simulation was performed. TID-induced degradation in nMOSFETs mainly induced the imprint effect in the SRAM cell, which is consistent with the measured results under the proton environment, but cannot explain the phenomena observed under heavy ion environment. A possible explanation could be the contribution from the radiation-induced GIDL in pMOSFETs.
6 November 2017 in Science China Information Sciences
Basing our findings on our previous pulsed laser testing results, we have experimentally demonstrated that there is an inflection point of a single event transient (SET) in the silicon-germanium heterojunction bipolar transistors (SiGe HBTs) with a decreasing temperature from +20 °C to −180 °C. Additionally, the changes in the parasitic resistivity of the carrier collection pathway due to incomplete ionization could play a key role. In this paper, we found that the incident-heavy ion’s parameters could also have an important impact on the SET inflection point by introducing the ion track structures generated by Geant4 simulation to the TCAD transient simulation. Heavy ion with a low linear energy transfer (LET) will not trigger the ion shunt effect of SiGe HBT and the inflection point will not occur until −200 °C. For high LET ions’ incidence, the high-density electron-hole pairs (EHPs) could significantly affect the parasitic resistivity on the pathway and lead to an earlier inflection point. The present results and methods could provide a new reference for the effective evaluation of single-event effects in bipolar transistors and circuits at cryogenic temperatures and provide new evidence of the SiGe technology’s potential for applications in extreme cryogenic environments.