In this study, zinc oxide (ZnO) as well as ZnO/GO (zinc oxide/graphene oxide) were successfully synthesized. The Carica papaya leaf extract was used to synthesize ZnO and oil palm empty fruit bunch biomass to obtain graphene, which was further used to obtain graphene oxide. The samples were characterized through a variety of analytical methods such as scanning electron microscopy, transmission electron microscopy, X-ray diffraction analysis, Fourier transform infrared spectroscopy and UV–Visible spectroscopy in order to understand their morphology, size, structural phase purity, functional groups and optical properties. Various peaks such as O-H, Zn-OH and Zn-O were found in the case of ZnO. Some additional peaks, such as C-C and C=C, were also been detected while analyzing the sample by Fourier-transform infrared spectroscopy. The results of the XRD and SEM studies demonstrated that the synthesized material shows the crystalline nature of the substance in the case of ZnO, and the crystallinity decreases for ZnO/GO. The average crystallite size was found to 80.0 nm for ZnO and 74.0 nm for ZnO/GO. Further, a red shift was shown in the case of ZnO/GO, which was indicated by the UV–Vis absorption spectrum. In the TEM analysis, the particles were shown to be nanosized. For instance, the highest number of particles was found in the range of 100 to 120 nm in the case of ZnO, while 80–100 nm sized particles were found for ZnO/GO. Using synthesized ZnO and ZnO/GO, the decolorization of methylene blue was found to be 64% and 91%, respectively.

Soil is a heterogeneous material, and its properties are vital from an agricultural perspective and for groundwater management. However, limited studies have been performed on the soil characteristics (soil texture, water-holding capacity, and soil compositions) of a single pumping well, especially in Malaysia. This article focuses on the soil characteristics and elemental analysis of a single borehole with 11 samples collected around Labu Kubong, Perak. The soil properties were analyzed in the context of particle size distribution (PSD) using the laser diffraction method (LDM), as well as soil composition for elemental analysis using a scanning electron microscope coupled with an energy dispersive X-ray (SEM-EDX). The LDM results revealed the average percentage of clay, silt, and sand to be 0%, 6%, and 94%, respectively, indicating most particles comprised sand particles which in percentages demonstrated a sandy texture with less silt content. Additionally, the water holding capacity is low because of major coarse sand particles in alluvial formations. Moreover, SEM-EDX outcomes displayed an average percentage of elemental composition reported as follows: C (40.77%), O (34.33%), Si (10.66%), Al (5.82%), Fe (1.10%), K (1.10%), As (0.05%), Na (0.04%), and Be (5.62%). Consequently, SEM-EDX outcomes showed these elements were derived from silicified quartz, feldspar, and iron-bearing minerals that originated from shale formations, and the presence of carbon indicates peat formation. Therefore, this study provides information on a single pumping well from an irrigation practice, and this study also recommends regional to global scale studies for supporting sustainable groundwater development worldwide.