Binaural synthesis with head tracking is often used in spatial audio systems. The devices used for head tracking must provide data on the orientation of the listener’s head. These data need to be highly accurate, and they need to be provided as fast and as frequently as possible. Therefore, head-tracking devices need to be equipped with high-quality inertial measurement unit (IMU) sensors. Since IMUs readily include triaxial accelerometers, gyroscopes, and magnetometers, it is crucial that all of these sensors perform well, as the head orientation is calculated from all sensor outputs. This paper discusses the challenges encountered in the process of the performance assessment of IMUs through appropriate measurements. Three distinct hardware platforms were investigated: five IMU sensors either connected to Arduino-based embedded systems or being an integral part of one, five smartphones across a broad range of overall quality with integrated IMUs, and a commercial virtual reality unit that utilizes a headset with integrated IMUs. An innovative measurement method is presented and proposed for comparing the performance of sensors on all three platforms. The results of the measurements performed using the proposed method show that all three investigated platforms are adequate for the acquisition of the data required for calculating the orientation of a device as the input to the binaural synthesis process. Some limitations that have been observed during the measurements, regarding data acquisition and transfer, are discussed.
The pandemic of COVID-19 and the resulting countermeasures have made it difficult or impossible to perform listening tests in controlled laboratory environments. This paper examines the possibility of using speech for level calibration of sound reproduction systems used in listening tests performed in non-laboratory conditions, i.e., when such tests are distributed through the means of electronic communication and performed in a home environment. Moreover, a larger pool of potential test subjects can be reached in this manner. The perception of what the “normal” level of reproduced speech should be was examined through a listening experiment by letting the listeners set the level of reproduced speech samples as they saw fit, depending on the used sound reproduction system, the (non)existence of visual stimulus, and the voice of the speaker. The results show that the perception of normal speech level is highly individual when it comes to setting that level by listening to reproduced speech. The interindividual differences between the subjects are considerably larger than the impact of the three main effects. The understanding of what the “normal” level of read speech should be was examined experimentally as well by asking the subjects to read a paragraph of text, depending on the visual stimulus. The results show that the “normal” level of read speech is reasonably consistent and averages at 55 dBA at a normal conversational distance of 1 m, in a room with room acoustics conditions typical for home environment and low background noise, and with the visual stimulus that mimics the interlocutor put within the personal space of the reader. A preliminary proposal is given of a level calibration method for non-laboratory listening experiments based on these results, and some of its aspects that require further research are discussed.