This research investigates the principle of insulating polymeric triboelectrification based on the mass transfer mechanism by using nanocomposites experimentally and computationally for the efficient development of triboelectric energy devices.
Thin films of p‐ and n‐type organic semiconductors for thermoelectrical (TE) applications are produced by doping of tetrathiotetracene (TTT). To obtain p‐type material TTT is doped with iodine during vacuum deposition of thin films or by postdeposition doping using controlled exposure to iodine vapors. Thermal codeposition in vacuum of TTT and tetracyanoquinodimethane (TCNQ) is used to prepare n‐type thin films. The attained thin films are characterized by measurements of the Seebeck coefficient and electrical conductivity. The Seebeck coefficient and conductivity can be varied by altering the doping level. p‐type TTT:iodide thin films with a power factor of 0.52 μW m−1 K−2, an electrical conductivity of 130 S m−1, and a Seebeck coefficient of 63 μV K−1 and n‐type TCNQ:TTT films with a power factor of 0.33 μW m−1 K−2, an electrical conductivity of 57 S m−1, and a Seebeck coefficient of −75 μV K−1 are produced. Engineered deposition of both p‐ and n‐type thermoelectric conducting elements on the same substrate is demonstrated. A proof of concept prototype of planar thin film TE generator based on a single p–n couple from the organic materials is built and its power generation is characterized.
In this paper we describe the principles of operation as well as the fabrication and testing steps of an all-organic waveguide modulator. The modulator comprises an SU-8 core and an electro-optic host-guest polymer cladding. The polymer properties are tuned in order to achieve single mode operation. We used direct-write laser lithography in two steps for the preparation of the devices. The electro-optic coefficient of the polymer is estimated from observing the modulation of the device operated in push-pull mode.
Triboelectric nanogenerator (TENG) devices are exemplar systems for mechanical‐to‐electrical energy conversion due to their simplicity and promising performance. However, little attention has been paid to recycling or reusing TENG devices. Indeed, most TENG devices are based on non‐biodegradable polymers, and thus end up in a landfill. Developing biodegradable triboelectric materials is crucial to mitigate negative environmental impacts from their growing use, however, it is challenging to identify such a materials that generate an applicable charge. Herein, such a biodegradable polymer triboelectric pair is demonstrated, by combining poly(butylene succinate) (PBS) films with microcrystalline cellulose (MCC) filler. A power density of 143 mW m −2 and a charge density of 1.36 nC cm −2 is measured when contacting pristine PBS with 70 wt% MCC/PBS composite film, which is comparable to polydimethylsiloxane‐based TENGs under identical testing conditions. These devices are shown to degrade via composting at 58 °C over 70 days, enabling long‐term (>10 000 cycle) performance and degradation upon disposal. It is suggested that this approach can be extended to control triboelectric properties for other biodegradable polymers. The technology and concepts developed herein directly address the United Nations Sustainable Development Goals for Responsible Consumption & Production and Affordable and Clean Energy.