Based on the experimental and theoretical signals of an open photoacoustic cell operating with modulation frequencies from 20 Hz to 20 kHz, a significant contribution of photogenerated excess carriers on the thermal and thermoelastic responses of an n-type silicon plate is observed for the very first time. This is achieved by comparing the measured amplitude and phase of the photoacoustic signal with their corresponding theoretical thermoelastic counterparts, for high enough modulation frequencies mainly. It is shown that the amplitude of the thermoelastic component of plasma-thin samples varies about two orders of magnitude with respect to the corresponding one of plasma-thick samples. Furthermore, we find a maximal temperature difference ΔT = − 35 nK between the illuminated and non-illuminated sample surfaces, which shows that thin silicon plates with excess carriers could be used as heat sinks.
In this paper, a theoretical model of temperature variations is derived for a two-layer optically absorbing structure, including thermal memory effects. It is considered that the two-layer structure is surrounded by gas and illuminated on the front side by a harmonically modulated laser beam. This model is based on the hyperbolic theory of heat conduction and Beer–Lambert's law of absorption neglecting multiple optical reflections in each layer. The derived model represents the generalization of the current models in two aspects. First, the influence of thermal memory properties of both layers is accounted for, and second, both layers are regarded as volume absorbers of the incident light. Based on the derived model, the expressions for surface temperature variations are given and discussed for the special type of two-layer structures, irradiated on the coated side, which is a prominent configuration in photoacoustic and photothermal experiments. It is shown that there exists a frequency range in which the influence of the thermal properties of the coating cannot be neglected, especially at the high-frequency range in which thermal memory of coating becomes significant. It is an important result in terms of understanding experimentally measured photothermal and photoacoustic response and, consequently, accurate characterizations of various high optically reflected and/or optically transparent samples by using these experimental techniques.
In this paper, a self-consistent inverse procedure is developed for the estimation of linear thermal expansion coefficient and thermal diffusivity of solids from transmission photoacoustic measurement. This procedure consists of two single-parameter fitting processes applied alternately: phase data are fitted by shifting thermal diffusion coefficient, while amplitude data are fitted by shifting thermal expansion coefficient. Each fitting process uses the resulting parameter of the other, previously finished one, thus converging to the best solution-pair achievable. In numerical experiments, the convergence proves to be very fast. The achieved parameter estimation error is as low as 1%, and it can be lowered further more by increasing the fitting resolution in parameter space. The application of the procedure on experimentally obtained aluminum photoacoustic response (measurements) on three thickness levels returns the estimates of its thermal diffusion and thermal expansion coefficients within expected literature boundaries.