jianhang Hu

Prof. Dr. jianhang Hu


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 June 2022 in Bioresource Technology
Verified
Journal Article
Closed access
CMChaowei Ma
Chaowei Ma
FZFengxia Zhang
Fengxia Zhang
HLHuili Liu
Huili Liu
HWHua Wang
Hua Wang
JHjianhang Hu
jianhang Hu

1 March 2022 in Bioresource Technology
Verified
Journal Article
Closed access
FCFangjun Chen
Fangjun Chen
FZFengxia Zhang
Fengxia Zhang
SYShiliang Yang
Shiliang Yang
HLHuili Liu
Huili Liu
HWHua Wang
Hua Wang
JHjianhang Hu
jianhang Hu

24 December 2021 in Fuel
Verified
Journal Article
Closed access
RDRuihan Dong
Ruihan Dong
FCFangjun Chen
Fangjun Chen
FZFengxia Zhang
Fengxia Zhang
SYShiliang Yang
Shiliang Yang
HLHuili Liu
Huili Liu
JHjianhang Hu
jianhang Hu

3 February 2016 in BioResources
Verified
Journal Article
Open access
PDF file
ALAng Li
Ang Li
HLHui-Li Liu
Hui-Li Liu
HWHua Wang
Hua Wang
HXHuan-Bin Xu
Huan-Bin Xu
LJLi-Fu Jin
Li-Fu Jin
JHjianhang Hu
jianhang Hu
Effects of Temperature and Heating Rate on the Characteristics of Molded Bio-char

2 March 2023 in Energies
Verified
Journal Article
Open access
PDF file
WLWenjie Li
Wenjie Li
SWShibo Wang
Shibo Wang
Jianxin XuJianxin Xu
Jianxin Xu
JHjianhang Hu
jianhang Hu
HWHua Wang
Hua Wang
DLDongbo Li
Dongbo Li
Oxygen lances are key equipment for copper converters. The effect of the lance arrangement on the mixing of a gas–slag two–phase is discussed using numerical simulation and experimental verification with a water model, and the stirring characteristics enhanced by variable–velocity blowing are explored. The results showed that the single–row lance arrangement (SA) increased the average velocity in the slag phase by 17.93% and reduced the disturbance to the metal phase by 27.78% compared to the double–row lance arrangement (DA). Compared to the constant–velocity blowing system (CSB), the sine–wave blowing system (SWB) and rectangular–wave blowing system (RWB) increased the average velocity in the slag phase by 24.03% and 13.96%, respectively, and reduced the proportion of the low–velocity area by more than 46.2%. The velocity imbalance in the SA local area enhances the mixing of the gas–slag two–phase. The variable–speed blowing improves the mass transfer and mixing effect.

25 May 2022 in Sustainable Energy & Fuels
Verified
Journal Article
Closed access
PDF file
LHLusheng Huai
Lusheng Huai
FZFengxia Zhang
Fengxia Zhang
SYShiliang Yang
Shiliang Yang
HLHuili Liu
Huili Liu
HWHua Wang
Hua Wang
JHjianhang Hu
jianhang Hu
Gasification experiments on grape branches were carried out in a self-improved downdraft gasifier at 800 °C, under atmospheric pressure, using air, steam, and air–steam as gasifying agents. The effects of the secondary air inlet position (0–75 cm beneath the reactor's top), ER (0.1–0.3), S/B mass ratio (0.5–2.5 g g−1), and S/B mass ratio (0.3–1.2 g g−1) with ER = 0.1 on the characteristics of biomass gasification were investigated. The results suggested that when the secondary air inlet position is 45 cm beneath the reactor's top, the gas yield, combustible gas content and CGE all reached the maximum value. In this case, a high-temperature zone with the largest volume and uniform temperature formed in the oxidation and reduction zones for better tar cracking and reduction reactions. The highest CGE of 59.14% was achieved when using air as the gasifying agent with the ER at 0.2. Increasing the S/B mass ratio causes an increase in H2 content, gas yield, CCE, and CGE, but a decrease in CO content and LHV. Due to the low loading rate of the gasifier, the negative effects of steam were not observed in the S/B mass ratio range of 0.5 to 2.5 g g−1. The air addition releases extra heat by boosting oxidation reactions, resulting in a greater gas yield, CCE, CGE, and H2 yield than pure steam gasification. It is advised that the ER be kept lower or equal to the optimum value and S/B mass ratio slightly higher than the optimum value to maximize H2 production.