The Chinese Fusion Engineering Testing Reactor (CFETR) is a project proposed by the Chinese fusion community to bridge the gap between ITER and a commercial fusion power plant with fusion power up to 1 GW. The mitigation of divertor target heat fluxes for such a powerful machine is a challenging problem, which might appear to be more severe than in ITER. In the present paper, the results of the CFETR advanced divertor optimization by SOLPS-ITER modeling with full drifts and currents activated are presented. Three divertor geometries, which differ by the distance from the X-point to the strike point on the outer target, are considered. Argon (Ar) and neon (Ne) are compared as seeded impurities. It is demonstrated that for all three geometries and for both radiators it is possible to achieve acceptable divertor heat loads (below 5 MW m⁻²) without notable fuel dilution (Z _eff < 2.5). Impurity compression in divertors and pedestal radiation are compared for two gases. Similar core plasma and divertor conditions, as well as radiated power fraction, may be achieved with 2–3 times less Ar seeding rate than the Ne one. Estimated radiation from the confined region appears to be small compared to the exhaust power. However, in all modeling cases the T _e at the far scrape-off layer part of both targets remains significantly above 5 eV, which might cause tungsten (W) sputtering. Further optimization of target shape will be performed to reduce the electron and ion temperature.

One of the major challenges for the Gigawatt-class Chinese Fusion Engineering Testing Reactor (CFETR) is to efficiently handle huge power fluxes on plasma-facing components , especially the divertor targets. This work investigates the effects of two candidate radiation impurity species, argon (Ar) and neon (Ne), with two different divertor geometries (baseline and long leg divertor geometry) on the reduction of steady-state power load to divertor targets in CFETR by using the SOLPS-ITER code package with full drifts and kinetic description of neutrals. The modeling results show clearly that increasing the seeding rate of Ar or Ne with fixed fueling gas D₂ injection rate reduces the target electron temperature and heat flux density for the baseline divertor geometry, which can be reduced further by higher D₂ injection rate. With a high impurity seeding rate, partial detachment with steady-state power load at the divertor target below the engineering limit of 10 MW m⁻² is demonstrated. In addition, the radiation efficiency for Ar is better than that for Ne. Increasing the divertor leg length reduces the electron temperature and heat load at the targets. This modeling, therefore, suggests that a long leg divertor design with Ar seeding impurity is appropriate to meet the CFETR divertor requirements.