Exploring non-precious metal-based catalysts for oxygen reduction reactions (ORR) as a substitute for precious metal catalysts has attracted great attention in recent times. In this paper, we report a general methodology for preparing nitrogen-doped reduced graphene oxide (N–rGO)-supported, FeCo alloy (FeCo@N–rGO)-based catalysts for ORR. The structure of the FeCo@N–rGO based catalysts is investigated using X-ray diffraction, scanning electron microscopy, X-ray photoelectron spectroscopy, and transition electron microscopy, etc. Results show that the FeCo alloy is supported by the rGO and carbon that derives from the organic ligand of Fe and Co ions. The eletrocatalytic performance is examined by cyclic voltammetry, linear scanning voltammetry, Tafel, electrochemical spectroscopy impedance, rotate disc electrode, and rotate ring disc electrode, etc. Results show that FeCo@N–rGO based catalysts exhibit an onset potential of 0.98 V (vs. RHE) and a half-wave potential of 0.93 V (vs. RHE). The excellent catalytic performance of FeCo@N–rGO is ascribed to its large surface area and the synergistic effect between FeCo alloy and N–rGO, which provides a large number of active sites and a sufficient surface area.
Boron powder is an additive for metalized explosives with great application potential. To improve the energy release ability of boron powder, the composites of RDX and nano-boron (RDX@Nano-B) were prepared by the spray-drying process, and the metalized explosives based on it were designed (named PBX-B1). The detonation heat and explosion pressure of boron-containing explosives PBX-B1 under vacuum and air conditions were measured and analyzed by an internal explosion test. On the other hand, the equilibrium pressure and energy release of the PBX-B1 explosive system after detonation were analyzed and compared with that of an explosive formulation of the same composition (named PBX-B2). Results showed that the detonation heat of PBX-B1 was 7456 J/g in a vacuum environment, which was 34.8% higher than that of RDX (5530 J/g). However, in the air environment, the detonation heat of PBX-B1 increased by 19.2% compared with that in the vacuum environment, and the explosive gas products mainly included N2, NOx, CO, H2O, CH4, HCN, and CO2. The peak pressure and equilibrium pressures of PBX-B1 were 11.2 and 0.42 MPa, which were increased by 155% and 75% compared with the vacuum environment, respectively. It is worth noting that, compared with that of PBX-B2, the released energy in the aerobic combustion stage and equilibrium pressure of PBX-B1 were increased by 49.8% and 10.5%. This study demonstrated the strategy of improving the energy release of boron-containing metalized explosives through the design of an explosive microstructure, which provides important clues for the design of higher-energy metalized explosives.