The paper presents a “hardware in the loop” emulator for a wind turbine system, used to tune and test in the laboratory the generator and the associate power electronics and control. The emulator includes: a Matlab/Simulink model of the wind turbine, an a.c. drive with direct torque control (the wind turbine equivalent) coupled with the real generator and the corresponding load. Digital simulations compared with experimental results are presented to validate the wind turbine emulator.
The paper presents a microgrid structure, based on wind and photovoltaic (PV) renewable energies inputs, implemented in a dedicated configurable microgrid laboratory. The wind turbine is realized through a Hardware-in-the-Loop (HIL) emulator. PV energy can be taken from a set of panels or from a programmable DC source, which can implement the I-V characteristics of the real system. The microgrid configuration, its components and functionality are presented also through experimental results.
Electrical energy conversion and storage in DC systems, with increasing importance in industry, requires DC–DC power electronic converters with performances adapted to today’s requirements. In recent years, the applications of DC–DC converters have expanded, including energy storage management strategies, due to the use of supercapacitors for energy storage instead of—or together with—rechargeable batteries, in order to improve overall performance. This article presents a non-isolated, common-ground, bidirectional hybrid switched-capacitor DC–DC converter, which can be efficiently used for supercapacitor charging/discharging, due to its high voltage conversion ratio. The hybrid converter was obtained from the conventional bidirectional buck topology, inserting an “active” switched-capacitor cell. In addition to the high voltage conversion ratio, the switched-capacitor cell brings another important advantage: decreasing the values of all passive components without interrupting the input to the output ground path. All of these positive features were revealed through theoretical analysis and confirmed through digital simulations and experiments, proving that the hybrid converter performs well in both operating modes, with a smooth transition between them.
8 November 2022 in IEEE Transactions on Industry Applications
This paper presents the structure, analytical description, simulation results, and rather extended laboratory scale experiments on a minibus electric drive, using a supercapacitor (SC) as a storage element. The traction is implemented by a single interior permanent magnet synchronous motor (IPMSM), with Bonded-NdFeB Spoke PMs in axis d and flux barriers in axis q, fed by an inverter with vector control strategy. The power interface between the SC, the drive, and the power line (for SC fast charging) is implemented by a hybrid bidirectional DC/DC converter (HBDC). The case study refers to a 7t minibus on an urban driving cycle profile simulation, confirming the initial theoretical considerations and proposed technical solutions. In terms of lab work a 1:20 torque scale (20Nm) 5kW at 2.4-4.8 krpm IPMSM was designed, manufactured and tested both under no load and load conditions with simulation and test results under steady state compared and measured transients that confirm the expected performance.
In power electronic converters working with PWM discontinuous control loops is very often used. This paper analyses the implementation of a valley current mode (VCM) control in a bi-directional hybrid DC-DC converter (HBDC) used in renewable energy applications. Analytical descriptions, digital simulation and experimental results performed on a laboratory prototype are presented in order to prove the control operation in both power flow modes, emphasizing the transition between step-up and step-down regimes.