This paper focuses on a bidirectional hybrid dc-dc converter suitable as an interface between two dc voltage buses in various applications including microgrids. The switched-capacitor cell, incorporated in the converter topology, gives the advantage of high voltage conversion ratio without using a transformer. This paper analyses the converter operation and the stability in the step-up and step-down operating modes through the state-space averaging method and through the pulse width modulation switch model method applied on an equivalent circuit model. The converter employs a current controller designed in frequency domain based on the Bode plot, using the K factor method. The simulation results obtained by means of an average and a detailed switching model prove, in good correspondence, that the controller is able to track the reference current waveform with good dynamic performance. Experimental results obtained from a 2 kW converter prototype confirm the theoretical considerations and the simulation results.
The paper presents a microgrid structure, based on wind and photovoltaic (PV) renewable energies inputs, implemented in a dedicated configurable microgrid laboratory. The wind turbine is realized through a Hardware-in-the-Loop (HIL) emulator. PV energy can be taken from a set of panels or from a programmable DC source, which can implement the I-V characteristics of the real system. The microgrid configuration, its components and functionality are presented also through experimental results.
Electrical energy conversion and storage in DC systems, with increasing importance in industry, requires DC–DC power electronic converters with performances adapted to today’s requirements. In recent years, the applications of DC–DC converters have expanded, including energy storage management strategies, due to the use of supercapacitors for energy storage instead of—or together with—rechargeable batteries, in order to improve overall performance. This article presents a non-isolated, common-ground, bidirectional hybrid switched-capacitor DC–DC converter, which can be efficiently used for supercapacitor charging/discharging, due to its high voltage conversion ratio. The hybrid converter was obtained from the conventional bidirectional buck topology, inserting an “active” switched-capacitor cell. In addition to the high voltage conversion ratio, the switched-capacitor cell brings another important advantage: decreasing the values of all passive components without interrupting the input to the output ground path. All of these positive features were revealed through theoretical analysis and confirmed through digital simulations and experiments, proving that the hybrid converter performs well in both operating modes, with a smooth transition between them.
This paper proposes a bi-directional DC-DC converter used as interface between the battery stack and the DC bus in a microgrid application, highlighting its main feature that permits a large conversion rate, with a low number of semiconductors and without using transformers. Analytical descriptions, design aspects, digital simulation and preliminary experimental results are presented, in order to check its operation in both power flow modes, emphasizing the transition between step-up and step-down regimes. It is proved that a simple hysteresis controller is able to assure the stability and a smooth transition between battery charging and discharging modes. The transistors driving signals are complementary which gives the advantage of using a single PWM control.
A bidirectional hybrid switched inductor converter (BHSI) is proposed in this paper. The converter uses an inductor switching cell in order to achieve a wide voltage conversion range, smaller passive components, and lower stress on the active devices. Apart from these advantages, the introduction of the additional inductor in the switching cell does not increase the complexity of the control structure, as is usually the case with other topologies with multiple components. The BHSI is compared, in terms of inductor/capacitor energies and total device stress, to other state‐of‐the‐art topologies and its advantages are highlighted. Two 3 kW prototypes were built, using Si‐MOSFETs and GaN‐FETs, in order to analyse their performances from the efficiency point of view, and to validate the theoretical findings. The stability analysis of the converter is performed and tested in a supercapacitor storage application, resulting in a good operation in both charge and discharge modes.
In power electronic converters working with PWM discontinuous control loops is very often used. This paper analyses the implementation of a valley current mode (VCM) control in a bi-directional hybrid DC-DC converter (HBDC) used in renewable energy applications. Analytical descriptions, digital simulation and experimental results performed on a laboratory prototype are presented in order to prove the control operation in both power flow modes, emphasizing the transition between step-up and step-down regimes.