Haruichi Kanaya

Dr. Haruichi Kanaya

Department of Electronics, Kyushu University, Fukuoka 819-0395, Japan
orcid

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 March 2018 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Mohamed MansourMohamed Mansour
Mohamed Mansour
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya
This letter proposes a novel wideband rectifier circuit for RF energy harvesting. The proposed circuit can collect signals efficiently over broad bandwidth spanning from 0.87 to 2.7 GHz which includes UHF ISM 900 MHz, GSM 900 and 1800 MHz, wireless communication, PCS, and ISM 2.4 GHz. In order to obtain sufficiently large rectifier bandwidth, a matching circuit based on high-pass type L-section for lower band impedance matching and inductive L-section for higher band impedance matching is proposed. The rectifier circuit is constructed using voltage doubler configuration with Schottky diode SMS7630-005LF. The circuit is optimized and refabricated to compensate the undesired parasitic and obtain the required rectifier performance. Two prototypes were simulated, fabricated, and characterized. The rectifier has a measured conversion efficiency exceeding 30% from 870 MHz to 2.5 GHz at 0 dBm input power and a load terminal of 2 kΩ and a dc output voltage equal to 1 V. The circuit sensitivity may reach up to -20 dBm with dc output voltage 40 mV and 8% conversion efficiency. The maximum measured efficiency is 63% from 1.1 to 1.35 GHz.

20 March 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Mohamed MansourMohamed Mansour
Mohamed Mansour
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya

6 July 2020 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
MCMing Che
Ming Che
YMYuki Matsuo
Yuki Matsuo
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya
HIHiroshi Ito
Hiroshi Ito
TITadao Ishibashi
Tadao Ishibashi
KKKazutoshi Kato
Kazutoshi Kato
We developed a thermo-optic effect based silica optical phased array (OPA) chip and evaluated its tunability of phases of lightwaves. The THz waves, whose phases are controlled by the OPA chip, are generated from four arrayed uni-travelling-carrier photodiodes (UTC-PDs) based on heterodyne photomixng. Meanwhile, the UTC-PDs, which integrated with $4\times 4$ slot antennas, are fabricated on a monolithic InP substrate chip for 300-GHz wave beam combining and steering. Through the optoelectronic THz-wave phase control, the feasibility of 300-GHz beam continuous steering is successfully demonstrated in a range of 50°.

5 February 2019 in Sensors
Verified
Journal Article
Open access
PDF file
Mohamed MansourMohamed Mansour
Mohamed Mansour
Xavier Le PolozecXavier Le Polozec
Xavier Le Polozec
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya
This work addresses the design and implementation of a broadband differential rectifier (DR) combined with an Archimedean spiral dipole antenna (ASDA) for wireless power harvesting at low incident power densities below 200 μ W/cm 2 . The proposed design exhibits an improved RF-DC conversion efficiency over a wide frequency range from 1.2 to 5 GHz. This frequency band is associated with several wireless communication services, for instance, ISM, WLAN, 5G, LTE, and GPS applications. The receiving planar ASDA exhibits circular polarization and has an average measured gain of 4.5 dBi from 1.2 to 5 GHz. To enable a wide operating bandwidth, the rectifier circuit is constituted by two architectures, designated A and B. Each scheme is designed to harvest power efficiently across a specific bandwidth. The optimal performance of both rectifiers are obtained using the nonlinear harmonic-balance simulations. The antenna–rectifier integration yields a compact rectenna with a high-efficiency performance over the intended bandwidth from 1.2 to 5 GHz for an input power of 9 dBm and terminal load resistance of 1 k Ω . The total measured RF-DC conversion efficiency is maintained above 30% across the entire frequency range with a peak value of 61% achieved at 1.2 GHz. In comparison with similar architectures, the proposed rectenna maintains a stable output efficiency despite the wide fluctuations in the input frequency and also has a minimum footprint size (58 × 55 mm 2 ).

5 September 2022 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
MCMing Che
Ming Che
KKKazuya Kondo
Kazuya Kondo
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya
KKKazutoshi Kato
Kazutoshi Kato
In this study, generating and enhancing THz continuous/pulsed waves is achieved by fabricating a monolithic InP substrate chip of arrayed photomixers, where each photomixer includes an InP/InGaAs uni-traveling-carrier photodiode (UTC-PD) with integrated 1×4 planar slot antennas (PSAs). Through optoelectronic time-aligned and -gradient delays of lightwaves that couple to arrayed photomixers, the radiated THz waves yield both quantitative gain and spatial directional gain. To generate continuous 300 GHz waves, each UTC-PD is excited at a photocurrent of 3 mA to attain -15.79dBm THz power that exhibits 12dB combined gain by four arrayed UTC-PDs. Whereas, -17.71dBm THz pulse generation with a duration of 25 ps can be achieved at the same optical pump power. The results show that the power enhanced gain of THz pulses is around 10 dB, which is less than that of continuous THz waves, because a part of the generated frequency components of the THz pulse is significantly deteriorated by bandwidth-limited PSAs. Furthermore, by means of optoelectronic time-gradient delay with frequency-independent characteristics, we successfully demonstrate steering of continuous and pulsed THz waves repeatedly in a range of 30 $\circ$ and 20 $\circ$ , respectively. In conclusion, strengthening directional THz power by beam-combining and -steering with arrayed photomixers is a promising technique for effective generation of continuous/pulsed THz waves.

16 October 2020 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Mohamed MansourMohamed Mansour
Mohamed Mansour
SYShuya Yamamoto
Shuya Yamamoto
Haruichi KanayaHaruichi Kanaya
Haruichi Kanaya
Energy harvesting (EH) offers several benefits for integrating compact low-power wireless nodes into emerging microscale applications, such as the Internet of Things (IoT), wearable and implantable medical diagnosis, and so on. In this study, an optimum approach is developed to design an adaptive high-performance rectifier for EH wireless charging. The rectifier architecture is based on a simple voltage doubler configuration. The structure can be extended to achieve the desired output voltage level without altering the impedance matching network. The voltage doubler stage is duplicated symmetrically to increase the voltage to the desired levels. The matching circuit employs a simple L-network that consists of a series-inductive branch and a shunt LC branch. To verify the logical operation of this approach, two rectifier prototypes were developed, and the performance of each structure was separately evaluated and compared. The comparison shows good agreement between the simulation and measurement results of the two configurations. For example, the peak measured efficiency is 65% at an RF input power of 10 dBm, and the simulated value is 70% with a terminal load of 3.3 kΩ. The main objective of the proposed design is to enhance the output voltage without changing the matching network.