As urbanization increases, buildings require greater amounts of energy for heating and cooling, thereby necessitating the search for effective solutions. The courtyard is often considered a viable option; however, the limited availability and high cost of land resulting from rapid urbanization hinder its widespread use. Consequently, a courtyard with a cluster of buildings is proposed as a feasible solution to address land scarcity. Nonetheless, further investigation is required to effectively integrate this solution into neighborhood urban planning. This study examines the influence of three variables—courtyard orientation, courtyard size, and the arrangement of buildings around the courtyard—on the provision of cooling and heating for buildings. The research focuses on 216 experimental scenarios simulated using Revit software, which excels in its ability to accurately interpret input data and conduct real-time analysis depending on the variables of the building design. The results were recorded for the facades and ground, and the shaded area was computed for each scenario; following these measurements, the shadow areas on both the facade and ground were converted into percentages. The testing involved a group of buildings surrounding courtyards of four different shapes (square, rectangle, triangle, and circle). This approach aimed to identify the most efficient design for implementation in neighborhood planning contexts. The findings indicate that the shape of the courtyard significantly impacts cooling and heating of buildings. Specifically, the square courtyard is unsuitable for countries with Mediterranean climates, such as Jordan, as it can reduce shade coverage by 30%, leading to higher temperatures. Conversely, employing a rectangular courtyard results in a higher proportion of shadows compared to other shapes. The study further demonstrates the influence of the examined variables on the efficacy of the courtyard in cooling and heating of buildings.

This paper is a continuation of a previously published paper on this issue that studied the microencapsulation of calcium nitrate in urea-formaldehyde shell using Aerosol OT (AOT) in hexane solution. The aim of this paper is to determine the quantity of AOT that optimizes microcapsule distribution, diameter, and shell thickness. Different quantities of AOT, namely 0.25 g, 0.50 g, 1.5 g, and 2.5 g were dissolved in 180 g of hexane solution to prepare the continuous phase. A Scanning Electron Microscopy (SEM) was used to characterize the distribution and the diameters of the prepared microcapsules. A Transmission Electron Microscopy (TEM) was used to investigate the microcapsule shell thicknesses. The SEM images have shown that using 0.25 g of AOT may be insufficient to totally polymerize the whole quantity of the core materials into fully independent capsules. On the other hand, using 0.50 g of AOT has shown a uniform distribution and almost complete polymerization of the core material components into distinct microcapsules. Higher quantities of AOT (i.e., 1.50 g and 2.5 g) have resulted in agglomerated microcapsules and nonuniform distributions. The results have also demonstrated that the quantity of AOT does not have a significant impact on the microcapsule diameter. Microcapsule average shell thicknesses were found to decrease by increasing AOT amount up to 0.50 g and to increase again due to the agglomeration witnessed for increased AOT quantity. Accordingly, 0.50 g of AOT was recommended for the preparation of calcium nitrate microcapsules in future research work.