Vertical-cavity surface-emitting lasers (VCSELs) are the ideal optical sources for data communication and sensing. In data communication, large data rates combined with excellent energy efficiency and temperature stability have been achieved based on advanced device design and modulation formats. VCSELs are also promising sources for photonic integrated circuits due to their small footprint and low power consumption. Also, VCSELs are commonly used for a wide variety of applications in the consumer electronics market. These applications range from laser mice to three-dimensional (3D) sensing and imaging, including various 3D movement detections, such as gesture recognition or face recognition. Novel VCSEL types will include metastructures, exhibiting additional unique properties, of largest importance for next-generation data communication, sensing, and photonic integrated circuits.
The output characteristics, modal properties, far-field profiles, and dynamic modulation responses of semiconductor lasers with surface higher-order gratings fabricated by the standard photolithography are presented. Single-mode semiconductor lasers with 20th- and 37th-order gratings for the 1.55 µm wavelength range are realized. The single-mode semiconductor lasers with 20th-order gratings have lower threshold currents and higher slope efficiencies than those with 37th-order gratings. The surface higher-order grating placed closed to the output facet can deteriorate the vertical far-field profile of the semiconductor laser. However, the properties of the semiconductor laser’s single-mode operation are not affected by the surface higher-order grating’s position in the ridge waveguide. The −3 dB bandwidth of these single-mode semiconductor lasers can achieve 9 GHz at 100 mA, which is the highest, to the best of our knowledge, for such a kind of single-mode semiconductor laser with a surface higher-order grating.
We experimentally demonstrate for the first time to our knowledge electrically injected vertical-cavity surface-emitting lasers (VCSELs) with post-supported high-contrast gratings (HCGs) at 940 nm. The HCG-VCSELs have two posts to support the air-suspended HCGs, which are realized by simple fabrication without critical point drying. The HCG-VCSEL achieves a threshold current of about 0.65 mA and a side-mode suppression ratio of 43.6 dB under continuous-wave operation at 25°C. Theoretically the HCG-VCSEL with a-cavity for the transverse magnetic polarization has a smaller effective mode length of. Thus, the relaxation resonance frequency can be increased by 16% compared with that of the conventional VCSEL. The modulation speed of 100 Gbit/s for the HCG-VCSEL is expected in the on–off keying modulation format. Our easy design of HCG-VCSELs has great potential for applications in optical interconnects, sensing, illumination, and so on.
15 February 2021 in IEEE Photonics Technology Letters
Semiconductor lasers with surface high-order gratings have been fabricated and measured. $31^{\mathrm {st}}$ -order gratings were defined by the standard contact-type i-line photolithography near the front facet and subsequently etched into the ridges of the semiconductor lasers by the inductively coupled plasma. Both the static and dynamic characteristics were investigated. The threshold current and maximum output power are 22 mA and 12 mW, respectively. Side-mode suppression ratios are larger than 35 dB at bias currents except approximately 145 mA due to mode hopping. −3 dB bandwidth of the small signal response is 13.8 GHz at 130 mA. The eye diagram at a bit rate of 30 Gbps is clearly open.
High‐contrast subwavelength grating (HCG) and distributed Bragg reflector (DBR) are demonstrated to be able to tailor the dispersion independently. Herein, it is found that multiple‐shape dispersions can be realized by a metastructure, which consists of an HCG on the DBR. Such a simple structure exhibits the linear dispersions with band‐edge modes, the M‐shaped dispersion with a cavity mode, and the W‐shaped dispersion with a bound state in the continuum. The origins of these dispersions and the mode characteristics (field distribution and quality factor) in the dispersions are studied. This study is helpful to realize single‐mode high‐efficiency surface‐emitting lasers, optical sensors, and quantum electrodynamics.
Optical interconnects (OIs) are the only solution to fulfil both the requirements on large bandwidth and minimum power consumption of data centers and high-performance computers (HPCs). Vertical-cavity surface-emitting lasers (VCSELs) are the ideal light sources for OIs and have been widely deployed. This paper will summarize the progress made on modulation speed, energy efficiency, and temperature stability of VCSELs. Especially VCSELs with surface nanostructures will be reviewed in depth. Such lasers will provide new opportunities to further boost the performance of VCSELs and open a new door for energy-efficient OIs.