Maximum power transfer in solar microgrid applications is achieved by impedance matching with a dc-dc converter with maximum power point tracking by the incremental conductance method. Regulation and dynamic control is achieved by operating with continuous conduction. It can be shown that under stable operation, the required output inductor has an inductance versus current characteristic, whereby the inductance falls off with increasing current, corresponding to increasing incident solar radiation. This paper describes how a variable inductor whereby the inductor core progressively saturates with increasing current meets this requirement and has the advantage of reducing the overall size of the inductor by up to 75% and increases the operating range of the tracker to recover solar energy at low solar levels.
25 April 2014 in IEEE Transactions on Power Electronics
This paper investigates a novel pulse width modulation (PWM) scheme for two-phase interleaved boost converter with voltage multiplier for fuel cell power system by combining alternating phase shift (APS) control and traditional interleaving PWM control. The APS control is used to reduce the voltage stress on switches in light load while the traditional interleaving control is used to keep better performance in heavy load. The boundary condition for swapping between APS and traditional interleaving PWM control is derived. Based on the aforementioned analysis, a full power range control combining APS and traditional interleaving control is proposed. Loss breakdown analysis is also given to explore the efficiency of the converter. Finally, it is verified by experimental results.
20 December 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
To accelerate the broad application of silicon carbide (SiC) power MOSFETs, their short-circuit (SC) robustness and reliability must be thoroughly evaluated. This article, therefore, presents an overview of related research methods aiming to meet that objective. Topics reviewed include non-destructive tester (NDT) used to implement SC faults, extraction and analysis of degradation parameters, and failure analysis of SiC MOSFETs. Concerning NDT, its design criteria and methods for evaluating SC robustness are discussed. Then, the key parameters used to assess SC reliability and methods for investigating degradation mechanisms are discussed and summarized. Finally, failure analysis techniques and their contributions to failure mechanisms are reviewed.
With the development of space exploration, high-power and high-voltage power systems are essential for future spacecraft applications. Because of the effects of space radiation such as single event burnout (SEB), the rated voltage of power devices in converters for a spacecraft power system is limited to a level much lower than that for traditional ground applications. Thus, multi-level DC/DC converters are good choices for high-voltage applications in spacecraft. In this paper, a fault-tolerant strategy is proposed for a three-level flying capacitor DC/DC converter to increase the reliability with minimal cost. There is no extra hardware needed for the proposed strategy; the fault tolerance of the converter is only achieved by changing the software control strategy. A stage analysis of the proposed strategy is provided in detail for different fault locations and ratios between the input and output voltage. Finally, a simulation model and prototype are built to verify the effectiveness of the proposed strategy.
This paper proposes a novel scheme integrating full-duplex data communication into a wireless power transfer system. The power and data are transmitted on the same inductive link comprised of two coreless coils with taps. Frequency division multiplexing (FDM) technique is applied. The power and data are transmitted by using different frequency carriers. The duplexers are designed to implement full-duplex communication. The circuit model of the system is provided to analyze the power and data transfer performance. The crosstalk interference between power and data carriers is discussed. Finally, a prototype has been built to demonstrate the effectiveness of the proposed system.