Biobased Materials Research Group (BMRG), Chemical Engineering & Materials Science, Michigan State University, 228 S. Shaw Lane, East Lansing, MI 48824, USA
Dr. Neha Mulchandani
Biobased Materials Research Group (BMRG), Chemical Engineering & Materials Science, Michigan State University, 228 S. Shaw Lane, East Lansing, MI 48824, USA
The current work focuses on the fabrication of high-molecular-weight stereocomplex poly(lactic acid)/nanohydroxyapatite (sPLA/n-HAP)-based bionanocomposite for three-dimensional (3D)-printed orthopedic implants and high-temperature engineering applications. To achieve the same, n-HAP is grafted with poly(d-lactic acid) (PDLA) via in situ ring-opening polymerization of d-lactide, followed by blending with poly(l-lactic acid) (PLLA), which yields sPLA/n-HAP biocomposite with improved storage modulus even at temperatures higher than 140 °C. X-ray diffraction and calorimetric analysis ensure the presence of 100% stereocomplex crystallites of biocomposite along with significant improvement in the melting temperature (∼227 °C). Noteworthy improvements in the mechanical and gas-barrier properties of the developed biocomposites are achieved due to the uniform dispersion of n-HAP (∼60 nm) confirmed by morphological studies. An unusual improvement in elongation at break (∼130% at 1 wt % HAP loading) makes this composite a toughened material. However, the tensile strength is improved by ∼16%, whereas oxygen permeability and water vapor transmission rate are found to reduce by ∼48 and ∼34%, respectively. Interestingly, the developed material is processed as monofilament, followed to 3D printing to yield a middle phalanx bone as a representative example of orthopedic implants. In vitro studies reveal that cell adhesion and proliferation on the surface of the developed biocomposite support its biocompatible nature. This signifies the possible future aspects of the material in commercial biomedical and high-temperature engineering applications.
The current research unfolds the effect of block lengths, microdomain morphology and stereocomplexation on the mechanical properties of PLA-b-PCL-b-PLA triblock copolymers where PCL is involved to improve the poor extensibility of PLA. The linear triblock copolymers PLLA-b-PCL-b-PLLA and PDLA-b-PCL-b-PDLA (PLLA:poly (L-lactic acid) and PDLA:poly (D-lactic acid)) are made by two step ring opening polymerization and blended in a 1 : 1 ratio to achieve stereocomplex blends where the molecular weight of the terminal and the mid segment is tailored. The mechanical strength and elongation at break range from 13 MPa to 36 MPa and 540 to 950%, respectively, for the triblock copolymers with varied block lengths. Such wide-ranged mechanical properties are ascribed to the morphology of the self-assembled nanostructure of triblock copolymers as corroborated with the small angle X-ray scattering (SAXS) results. To render it industrially viable, the process of triblock copolymer synthesis is scaled up to ∼500 g batch followed by its processing using a twin-screw extruder to make a filament which is used for 3D printing of a mesh-type scaffold. The synthesized materials are tested for their biocompatibility by performing MTT assay using rat bone osteosarcoma (UMR-106) cells which renders them as potential biomaterials.