In offshore engineering, pile foundations are commonly constructed in marine deposits to support various structures such as offshore platforms. These piles are subjected to lateral cyclic loading due to wind, wave action, and drag load from ships. In this paper, centrifuge model tests are conducted to investigate the response of the existing single piles due to lateral cyclic loading. The cyclic loading was simulated by a hydraulic actuator. It is found that the residual lateral movement and bending strain are induced in the existing pile after each loading–unloading cycle. This is because plastic deformation is induced in the soil surrounding the existing pile during each loading–unloading cycle. By increasing the applied loads during cyclic loading–unloading process, the lateral movements and bending strains induced in the pile head increase simultaneously. As the cyclic loading varies from 10 to 50 kN, the residual pile head movement increases from 40 to 154 mm, and the residual bending strain of the existing pile varies from 100 to 260 με. The ratio of residual to the maximum pile head movements varies from 0.17 to 0.22, while the ratio of residual to the maximum bending strains is in a range of 0.12–0.55.

A pile group under lateral loading is a complex pile‒soil-pile interaction problem. In this study, numerical analysis was used to investigate the lateral behavior of pile groups arranged in a 3 × 3 configuration with varying piles spacings. The hypoplastic constitutive model embedded into ABAQUS software through the UMAT subroutine was used to characterize the stress‒strain relationship of Toyoura sand. The effects of the pile spacing on the load‒displacement relationship of the pile group, the bending moment-depth relationship of each pile in the pile group, the deflection-depth relationship, and the soil resistance distribution were investigated. The results indicate that the lateral bearing capacity of the pile group decreases by more than 50% when the pile spacing is reduced from 7D to 3D. When the pile spacing is greater than 5D, the “edge effect” of the laterally loaded pile group gradually decreases, and when the pile spacing is greater than 7D, the “shadowing effect” can be negligible, and the wedge-shaped failure zone of the pile group occurs within a depth of 5D below the mud surface.

In view of the overlapping project between the double track bridge of Ningbo-Taizhou-Wenzhou expressway and seawall, the large-scale three-dimensional finite element calculation is carried out by using the finite element software ABAQUS, the displacement limit of bridge pier top is studied, the internal force deformation of bridge pile foundation and its variation law in the process of seawall filling and later consolidation settlement are analyzed, and the influence of sea seawall filling on the stress and deformation of bridge pile foundation is studied. The calculation results show that: the main pier in the enclosure side of the two main piers in the design scheme is most affected by the construction of seawall. At the end of seawall construction, the longitudinal displacement along the bridge is 25.56cm, the transverse displacement is -10.68cm, and the settlement is 3.49cm. From the beginning of seawall construction to 15 years after the completion of seawall, the maximum longitudinal displacement along the bridge is -80.87cm, the maximum transverse displacement is -38.94cm, and the maximum settlement is 382.2cm, in which the settlement during the construction period is 346.0cm, accounting for 90.5%. The calculation results of design scheme show that the displacement of bridge pier top is too large, and the tensile stress of bridge pile is also large, therefore, it is necessary to optimize the design scheme to reduce the displacement of the bridge.