Hitoshi Haga

Prof. Dr. Hitoshi Haga

Electrical Engineering, Nagaoka University of Technology, Nagaoka, Kyōto, Japan
orcid

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 October 2017 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
KAKodai Abe
Kodai Abe
Hitoshi HagaHitoshi Haga
Hitoshi Haga
KOKiyoshi Ohishi
Kiyoshi Ohishi
YYYuki Yokokura
Yuki Yokokura
In order to reduce the cost and the size of a single-phase to three-phase power converter, an electrolytic capacitor-less single-phase to three-phase inverter is proposed. As the system does not have energy storage, such as an electrolytic capacitor, it results in source current harmonics due to the spatial harmonics of the motor. Adding an inductor for filtering the source current harmonics increases the cost and size of the system. In order to improve the source current waveform without adding passive components, it is necessary to reduce the source current harmonics via inverter control. However, when the inverter control reduces the source current harmonics, voltage saturation of the inverter causes source current distortion. At the rated speed and load, the voltage saturation region amounts to 40-50% of the source period, and the source current harmonics do not meet the guideline of IEC 61000-3-2. This paper proposes a direct dc-link current control (DDCCC) considering voltage saturation and the dq -axis current reference calculation for applying the DDCCC, which reduces the source current harmonics below the guideline. The effectiveness of the proposed method is verified through experiments.

10 June 2020 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
MNMotoki Nishio
Motoki Nishio
Hitoshi HagaHitoshi Haga
Hitoshi Haga
This paper proposes a power converter and control method to realize a high input power factor and constant motor torque using a dual inverter without an electrolytic capacitor and an open-end winding machine. The proposed system has the following features. First, the proposed control method achieves a high input power factor by pulsating the single-phase ac power without affecting the motor current. Second, the proposed control method compensates the pulsation the of load voltage by using an additional inverter. Third, the control method controls the dc bus voltage of the additional inverter. The proposed circuit configuration and control method contributes to the small size and weight, and high efficiency of the motor drive system with a single-phase power supply. The effectiveness of the proposed system is verified through experiments.

1 September 2009
Verified
Conference Paper
Closed access
HTHiroki Takahashi
Hiroki Takahashi
RHRyo Hisamichi
Ryo Hisamichi
Hitoshi HagaHitoshi Haga
Hitoshi Haga
This paper proposes a novel single-phase to three-phase power converter, which based on matrix converter. The proposed matrix converter has current-source type function and single-phase to three-phase power conversion. Output voltage waveforms of the proposed matrix converter have quite low harmonics. Furthermore, the proposed matrix converter has boost voltage ability. Hence, the proposed system can achieve high efficiency motor design. The proposed control method is based on virtual AC/DC/AC power conversion approach to determine the switching state of the proposed current-source type single-phase to three-phase matrix converter. Validity of the proposed system proves by simulation and experimental results.

30 November 2021 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
YOYuuki Ohno
Yuuki Ohno
Hitoshi HagaHitoshi Haga
Hitoshi Haga
This paper proposes a harmonic compensation method using an open-end winding IPMSM driven by an electrolytic capacitor-less dual inverter under grid disturbances. In a conventional electrolytic capacitor-less single inverter, harmonic currents are superimposed on the output current of the inverter owing to the increase in the DC-link voltage ripple caused by grid disturbances. Consequently, the reliability of the motor drive system is reduced, and the torque ripple causes mechanical vibrations. The proposed harmonic compensation method estimates the harmonic voltage and outputs it using a compensating inverter. The experimental results show that peak-to-peak of the motor current and the 150 Hz component of the shaft torque are reduced by 10.3 and 92.4 %, respectively, compared to the conventional system under unbalanced input voltage. Therefore, the improvement of reliability of a motor drive system and reduction of the torque ripple are achieved without an energy buffer under grid disturbances.

1 January 2020 in IEEJ Journal of Industry Applications
Verified
Journal Article
Closed access
PDF file
AMAkihito Mizukoshi
Akihito Mizukoshi
Hitoshi HagaHitoshi Haga
Hitoshi Haga
This paper proposes a method for improving the output voltage waveform of dual-inverter fed open-end winding induction motors in the low-speed region. The system consists of two isolated DC power supplies, an open-end winding induction motor, and two voltage source inverters, which are connected to the opposite terminals of the open-end winding with unequal DC-link voltages. The motor losses, which are caused by the harmonics of the voltage applied to the winding, increase when the inverter outputs a pulse-width modulated voltage at a low modulation index. The aim of this paper is to reduce the motor loss at low motor speeds by improving the winding voltage waveform. In the proposed control method, the use of the output voltage difference from the inverters constituting the dual-inverter lowers the peak voltage. In order to obtain the proposed waveform, a method for the space-vector pulse-width modulation of the dual-inverter is presented. Furthermore, this paper presents the commutation sequence of the PWM pattern considering the dead-time and switching device characteristics, especially the turn-off delay time. The proposed method is verified experimentally by driving a dual-inverter fed open-end winding induction motor. The experimental results confirm that the harmonic component of the output voltage, which is related to the switching frequency (5kHz), is reduced from 18.9V to 4.4V by using the proposed method at a motor speed of 300rpm and load torque of 1.43Nm.

28 December 2022 in World Electric Vehicle Journal
Verified
Journal Article
Open access
PDF file
ESEiichi Sakasegawa
Eiichi Sakasegawa
RCRin Chishiki
Rin Chishiki
RSRintarou Sedutsu
Rintarou Sedutsu
TSTakumi Soeda
Takumi Soeda
Hitoshi HagaHitoshi Haga
Hitoshi Haga
Ralph KennelRalph Kennel
Ralph Kennel
A boost converter is used in various applications to obtain a higher voltage than the input voltage. One of the current main circuit systems for hybrid electric vehicles (HEVs) is a combination of a two-phase boost converter (parallel circuit) and a three-phase two-level inverter. In this study, we focus on the boost converter to achieve even higher efficiency and propose an interleaving scheme for a boost converter suitable for a three-level inverter (series circuit). The series circuit has two capacitors connected in series and makes it suitable as a power supply for a three-level inverter. We analyze the input current ripple of the series and parallel circuit in order to show the superiority of the series circuit. Furthermore, we propose a novel output voltage control strategy using an optimal regulator, namely a Linear Quadratic Regulator (LQR), for the series circuit. As a result, we found the input current ripple of the series circuit is smaller than the parallel circuit and demonstrated the superiority of the series circuit. The simulation and experimental results show the effectiveness of the proposed interleaving scheme and optimal regulator.