The study aims to analyze the influence of complex service factors on ravelling resistance performance for large-void asphalt pavements by carrying out tests on environmental and vehicle factors, conducting ultraviolet aging, freeze–thaw cycles, as well as vehicle speed simulated tests with the Rotating Surface Abrasion Test, vehicle tests, and traffic volume tests, and by making a correlation analysis between the Cantabro Abrasion test and Rotating Surface Abrasion Test. The result shows that environmental factors significantly affect the ravelling resistance performance of drainage asphalt pavements. With the increase in the times of UV aging and freeze–thaw cycles, the ravelling loss rate of asphalt specimens shows a tendency to increase, and the combined test of UV aging and freeze–thaw cycles aggravated the ravelling damage of asphalt specimens. Meanwhile, vehicle factors have a significant attenuation effect on the ravelling resistance performance of drainage asphalt pavements. With the increase in the speed, pressure, and times of the Rotating Surface Abrasion, the ravelling loss rate of asphalt specimens shows a steady tendency to increase. Furthermore, there exists a good correlation between the Rotating Surface Abrasion speed, pressure, times, and the ravelling loss rate. Finally, the two test results of the Cantabro Abrasion test and Rotating Surface Abrasion test are consistent in their changes during single/composite factor analysis, confirming the feasibility of using the Rotating Surface Abrasion test index to characterize the change in the ravelling resistance performance of drainage asphalt pavements.
Porous asphalt pavements have a skeletal structure with a large number of interconnecting pores, which can improve drainage, ensure traffic safety, and reduce tire noise. However, it can weaken the mechanical properties of the pavement. One of the key factors affecting the performance of porous asphalt pavements is the quality of compaction, the assessment of which is difficult to accurately quantify. Therefore, Superpave gyratory compaction (SGC) and skeleton penetration tests of porous asphalt mixtures were carried out using three engineering-differentiated gradations in this paper to investigate the gyratory compaction characteristics and the skeleton contact state during penetration. The results show that obvious stages with the increase in number of cycles can be observed during the compaction process. All gradations can achieve the maximum porosity requirements within a reasonable number of compaction cycles, while only the medium and fine gradations can approximately meet the minimum porosity requirements. The coarse gradation takes too long to finish compaction and is almost impossible to meet the minimum porosity. The optimum match between the void ratio of the design gradation and the skeleton contact state can be verified using the VCA ratio and void ratio curves. This is a new method to determine the corresponding target compaction number that can ensure better accuracy and ease of engineering application. Moreover, medium-graded mixtures with better skeletal embedding exhibit greater skeletal strength than coarse-graded aggregates, which provide theoretical support for the establishment of material grade optimization methods.