The safety of deep geological repositories is important in the disposal of high-level radioactive waste (HLW). In this study, advection–dispersion experiments were designed to build a transport model through a calibration/validation process, and the transport behavior of tritiated water (HTO) and various iodine species (iodide: I− and iodate: IO3−) was studied on a dynamic compacted granite column. Breakthrough curves (BTCs) were plotted under various flow rates (1–5 mL/min). BTCs showed that the non-sorption effect by anion exclusion was observed only in I− transport because the retardation factor (R) of I− was lower than that of HTO (R = 1). Moreover, equilibrium and nonequilibrium transport models were used and compared to identify the mobile/immobile zones in the compacted granite column. The anion exclusion effect was influenced by the immobile zones in the column. The non-sorption effect by anion exclusion (R < 1) was only observed for I− at 5.0 ± 0.2 mL/min flow rate, and a relatively higher Coulomb’s repulsive force may be caused by the smaller hydration radius of I−(3.31 Å) than that of IO3−(3.74 Å).
In this study, a column experiment was employed to evaluate the nuclide migration behavior in the surrounding rock medium of a near-surface disposal site in China and to investigate the advection–dispersion behavior of tritium (H-3) and plutonium-238 (Pu-238) in highly weathered argillaceous shale. A reasonable numerical model was selected to fit the experimental breakthrough curves (BTCs) and to obtain the relevant migration parameters. The results show the following: (1) the internal structure of the highly weathered argillaceous shale exhibited heterogeneity, and the nuclide migration BTC showed characteristics of a “curve peak moving forward” and a “tail curve trailing”; (2) compared with other models, the stream tube mode could better fit the BTCs and obtain the average dispersion coefficient <D>, average distribution coefficient <Kd>, and other parameters; (3) compared to the results of the batch experiment, the distribution coefficient Kd obtained from the column experiment was smaller than that obtained from the batch experiment, which is speculated to be due to the influence of contact time and the contact area between the nuclide and the medium.
In this study,90Sr was used as the test radionuclide to characterize the sorption kinetics and effects of initial 90Sr activity and remaining 90Sr in solid concentration were simulated for a near-surface repository. The study focused on the sorption characteristics of radionuclides in unsaturated groundwater environment (or vadose zone) is the important information for investigating the near-surface disposal of intermediate and low-level radioactive waste (ILLW). Moreover, the 90Sr sorption experiments reached equilibrium within 56 h, which fit to the first order sorption kinetic model, and the remaining 90Sr in mudrock samples showed obvious sorption equilibrium hysteresis, which fit to the second order sorption kinetic model. Before reaching the maximum sorption capacity, the sorption rate constant increases with 90Sr increasing; the distribution coefficient (Kd) of 56 h decreases with the remaining 90Sr decreasing. In addition, it showed that the slow sorption process dominated before the sorption reaches equilibrium. In fact, a reliable safety assessment methodology for on-going near-surface repository required a lot of the radionuclides parameters with local environment including the radionuclides sorption/desorption rate constant and maximum sorption capacity.
Exploring the migration behavior of radioactive nuclides in the surrounding rock media of the disposal site is the basis for the safety evaluation of radioactive waste disposal sites. In this study, the column experiment was employed to evaluate the nuclide migration behavior in the surrounding rock medium of a near-surface disposal site in China and to investigate the advection–dispersion behavior of tritium (HTO) and plutonium-238 (238Pu) in highly weathered argillaceous shale with different degree of weathering. A reasonable numerical model was selected to fit the experimental breakthrough curves (BTCs) and obtain relevant migration parameters. The results showed that: (1) the breakthrough curves of HTO and 238Pu in fractured media with varying degrees of weathering exhibited clear “peak forward” and “tail dragging” phenomena; (2) the stream tube model can better fit the BTCs of the nuclides in the highly weathered fractures and obtain the average dispersion coefficient <D>, average distribution coefficient <Kd>, and other parameters; (3) the two-region non-equilibrium model can better fit the BTCs of the nuclides in the penetrating fractures and weak weathering fractures and obtain the volumetric water content of the mobile liquid region (θm), distribution coefficient (Kd), and other parameters.