The safety of deep geological repositories is important in the disposal of high-level radioactive waste (HLW). In this study, advection–dispersion experiments were designed to build a transport model through a calibration/validation process, and the transport behavior of tritiated water (HTO) and various iodine species (iodide: I− and iodate: IO3−) was studied on a dynamic compacted granite column. Breakthrough curves (BTCs) were plotted under various flow rates (1–5 mL/min). BTCs showed that the non-sorption effect by anion exclusion was observed only in I− transport because the retardation factor (R) of I− was lower than that of HTO (R = 1). Moreover, equilibrium and nonequilibrium transport models were used and compared to identify the mobile/immobile zones in the compacted granite column. The anion exclusion effect was influenced by the immobile zones in the column. The non-sorption effect by anion exclusion (R < 1) was only observed for I− at 5.0 ± 0.2 mL/min flow rate, and a relatively higher Coulomb’s repulsive force may be caused by the smaller hydration radius of I−(3.31 Å) than that of IO3−(3.74 Å).
An accurate and effective method combining ion chromatography (IC) and inductively coupled plasma optical emission spectrometry (ICP-OES) was applied in this work to qualitatively and quantitatively analyze individual and co-existing iodide (I−) and iodate (IO3−) at various concentrations. More specifically, a very strong linear relationship for the peak area for the co-existing I− and IO3− ions was reached, and a high resolution value between two peaks was observed, which proves the effectiveness of our combined IC-ICP-OES method at analyzing iodine species. We observed lower accessible porosity for the diffusion of both I− and IO3− in samples of bentonite clay using IC-ICP-OES detection methods, where the effective diffusion coefficient varied based on the anion exclusion effect and the size of the diffusing molecules. In fact, the distribution coefficients (Kd) of both I− and IO3− were close to 0, which indicates that there was no adsorption on bentonite clay. This finding can be explained by the fact that no change in speciation took place during the diffusion of I− and IO3− ions in bentonite clay. Our IC-ICP-OES method can be used to estimate the diffusion coefficients of various iodine species in natural environments.
Various numerical methods have been being extensively used to estimate the diffusion parameters of pertechnetate (99TcO4−) in compacted MX80 bentonite clay using through-diffusion (TD) techniques. In this study, an improved TD column test was applied, and the diffusion fluxes of tritium (HTO) as a non-reactive radionuclide, and 99TcO4− with various dry densities, were compared under the same experimental conditions. Similar results were obtained for the apparent diffusion coefficients of HTO and 99TcO4− using three estimation methods: a graphical method applying the asymptote calculation, an analytical solution using Lsqcurvefit installed in MATLAB, and the Marquardt–Levenberg optimization algorithm in the HYDRUS-1D inverse method. The statistical analysis showed that the densities using a one-way analysis of variance (ANOVA) for the three estimation methods ranged from 1200 to 2000 kg/m3, which indicated that there were no obvious differences between HTO and 99TcO4−. In general, the diffusion parameters of 99TcO4− were lower than those for HTO due to anion exclusion effects and lower accessible porosity.
Advection-dispersion experiments (ADE) were effectively designed for inadequate transport models through a calibration/validation process. HTO, selenium (Se), and cesium (Cs) transport in crushed granite were studied using a highly reliable, dynamic column device in order to obtain the retardation factors (R) and the dispersion coefficients (D) by fitting experimental breakthrough curves (BTCs) for various path lengths. In order to conduct a safety assessment (SA) of a deep geological repository for high-level radioactive waste, radionuclide transport in rock systems is necessary to clarify and establish a suitable model. A dynamic column with a radiotracer (HTO, Se(IV), and Cs) was applied to 2, 4, and 8 cm path lengths using a STANMOD simulation. The results showed similar results between the BTCs of Se and Cs by fitting a non-equilibrium sorption model due to the retardation effect. In fact, there was a relatively obvious sorption of Se and Cs in the BTCs obtained by fitting a retardation factor (R) value higher than 1. In addition, a two-region (physical) and a two-site (chemical) non-equilibrium model with either the lowest sum of squared residuals (SSQ) or the root mean square error (RMSE) were applied to determine the Se and Cs sorption mechanisms on granite.
In this study, a column experiment was employed to evaluate the nuclide migration behavior in the surrounding rock medium of a near-surface disposal site in China and to investigate the advection–dispersion behavior of tritium (H-3) and plutonium-238 (Pu-238) in highly weathered argillaceous shale. A reasonable numerical model was selected to fit the experimental breakthrough curves (BTCs) and to obtain the relevant migration parameters. The results show the following: (1) the internal structure of the highly weathered argillaceous shale exhibited heterogeneity, and the nuclide migration BTC showed characteristics of a “curve peak moving forward” and a “tail curve trailing”; (2) compared with other models, the stream tube mode could better fit the BTCs and obtain the average dispersion coefficient <D>, average distribution coefficient <Kd>, and other parameters; (3) compared to the results of the batch experiment, the distribution coefficient Kd obtained from the column experiment was smaller than that obtained from the batch experiment, which is speculated to be due to the influence of contact time and the contact area between the nuclide and the medium.
To address the issue of radioactive waste generated by the large-scale promotion and use of nuclear energy, safety evaluations of disposal sites in various surrounding rocks are essential. These evaluations are a prerequisite for ensuring the long-term safe disposal of radioactive waste. This study focuses on the blocking capacity of clay rocks concerning the advection–dispersion behavior of representative radionuclides such as 137Cs, 79Se, and 99Tc. It further examines the effects of competitive adsorption that arise when these three radionuclides coexist. (Since 79Se is difficult to obtain, 75Se was used as a substitute nuclide. In the mixed-nuclide experiments, the stable isotope Re was used to replace 99Tc.) The experimental findings revealed that competitive adsorption can significantly reduce the adsorption capability of clay rocks for 137Cs and 79Se, altering the adsorption mechanism. During the advection–dispersion process, the weak adsorption sites of 137Cs and 79Se on clay rocks become active after the strong adsorption sites are preferentially occupied, resulting in a decline in both adsorption quantity and rate. In the case of 99Tc, competitive adsorption weakens the effect of anion repulsion, leading to a reduction in the immobile liquid regions (θim).