Non-utility owned distributed energy resources (DERs) are mostly untapped currently, but they can provide many grid services such as voltage regulation and service restoration, if properly controlled, and can improve the distribution system's reliability when coordinated with utility-owned assets such as self-healing control and microgrids. This paper integrates transactive energy control into the distribution system reliability evaluation to quantitatively assess the impact of non-utility owned DERs on reliability improvement. A transactive reactive power control strategy is designed to incentivize the DERs to provide reactive power support for improving voltage profiles thus enabling additional customer load restoration during an outage. Also, an operational sequence to coordinate the non-utility owned DERs with the utility owned self-healing control and utility owned microgrids is designed and integrated into the service restoration process with the operational constraints guaranteed by checking the three-phase unbalanced power flow for post-fault network reconfiguration. The reliability indices are then calculated through a Monte Carlo simulation. The transactive reactive power control strategy is tested on a four-feeder distribution system operated by Duke Energy in the U.S. Results demonstrate that the non-utility owned DERs with the transactive control improve the reliability of both the system and critical loads by more than 30%.

Multiple severe forced oscillation events have recently been observed across the North American interconnections and around the world. These forced oscillations have caused power swings, limited power transfer capability, damaged equipment, and persisted indefinitely until the driving source was located and removed. This paper proposes a comprehensive method to mitigate forced oscillations. Once a forced oscillation is detected, a new source location algorithm can be used to locate the source based on the oscillation mode angle without requiring system topology information. If the source cannot be quickly located and removed, a control strategy can be activated to modulate the active power of utility-scale inverter-based battery energy storage systems (BESSs) to reduce the energy of forced oscillations to a safe level and allow sufficient time for locating the exact source. The proposed source location algorithm is validated using measurements collected during the January 11, 2019 forced oscillation event in North America and other actual grid events, while the proposed control strategy is verified using the Eastern Interconnection dynamic model under the replicated January 11, 2019 forced oscillation event. The simulation results demonstrated that the proposed source location algorithm can accurately identify the forced oscillation source, and the proposed control strategy can significantly reduce forced oscillation energy.

Distribution System State Estimation (DSSE) infers the states (e.g., voltage phasors) using measurements from the electric distribution grid. As the distribution network becomes more active due to the increasing penetration of Distributed Energy Resources (DER), a deeper investigation into conventional DSSE approaches is needed. This review paper focuses on state-of-the-art techniques and challenges for DSSE in the context of emerging concepts, such as new sensor technologies, data-driven approaches, and high DER penetration.

In contrast with conventional microgrids (MGs) with fixed boundaries, a smart and flexible MG with dynamic boundary is introduced in this paper. Such a MG can dynamically change its boundary by picking up or shedding load sections of a distribution feeder depending on its available power, leading to more flexible operation, better utilization of renewables, smaller size of energy storage system, higher reliability, and lower cost. To achieve a flexible MG, the main challenges in MG design are addressed, including recloser placement, MG asset sizing considering resilience, system grounding design, and protection system design. Meanwhile, a hierarchical structure is employed to design and implement the MG controller. On top of the functions defined in IEEE 2030.7-2018, a few new functions, e.g., online topology identification and PQ balance, are added, while the planned/unplanned islanding and reconnection functions are enhanced. The controller is implemented on a CompactRIO, a general-purpose hardware platform provided by National Instruments (NI), and tested on a controller hardware-in-the-loop setup based on an OPAL-RT real-time simulator and a reconfigurable power electronic converter-based hardware testbed. The test results have validated the performance of the developed controllers. Such a flexible MG and its controller have been deployed at a municipal utility, and part of the controller’s functions have been tested on-site.

This paper proposes a novel method for solving and tracing power flow solutions with changes of a loading parameter. Different from the conventional continuation power flow method, which repeatedly solves static AC power flow equations, the proposed method extends the power flow model into a fictitious dynamic system by adding a differential equation on the loading parameter. As a result, the original solution curve tracing problem is converted to solving the time domain trajectories of the reformulated dynamic system. A non-iterative algorithm based on differential transformation is proposed to analytically solve the aforementioned dynamized model in form of power series of time. This paper proves that the nonlinear power flow equations in the time domain are converted to formally linear equations in the domain of the power series order after the differential transformation, thus avoiding numerical iterations. Case studies on several test systems including a 2383-bus system show the merits of the proposed method.

Wind power generation is hierarchically organized and can be aggregated/disaggregated based on geography and electrical network structure. Forecasts are required at all levels of such a hierarchy for different operational requirements, which are also known as “hierarchical forecasts”. In this paper, we propose a new method to produce hierarchical wind power forecasts which performs better than the conventional top-down or bottom-up method. At first, wind power generation at all levels of the hierarchy is independently forecasted using state-of-the-art techniques. Then, a least squares regression model is used to optimally reconcile these base forecasts. Adjusted forecasts are as close as possible to base forecasts but also satisfy the requirement of the aggregate consistency (i.e., the lower-level forecasts add up exactly to the higher-level forecasts). Case studies validate the effectiveness of the proposed approach for very short-term wind power forecasts. The accuracy improvement of reconciled forecasts over benchmarks is confirmed at all levels of the hierarchy, regardless of forecast horizons and hierarchical structures.