The increase in greenhouse gas emissions has led to seawater acidification, increasing the corrosion rate of metal structures in marine applications. This paper indicates that the spraying of four types of coatings, namely Zn, Al, Zn-Al, and Al-Mg, using the arc-spraying technique on steel substrate S235JR, creates effective protective coatings that interact differently with various pH solutions exposed to varying levels of seawater acidification. The study analyses the structural properties of the coating materials using SEM and XRD techniques. Electrochemical parameters are evaluated in solutions with different pH and salinity levels. The results demonstrate that alloy metallic coatings provide excellent resistance to corrosion in low-pH solutions.
The present paper presents a study of the behaviour of Fe3Al intermetallic powders particles based on 86Fe-14Al, 86Fe-14(Fe5Mg), and 60.8Fe-39.2(Ti37.5Al) compositions obtained by mechanochemical synthesis at successive stages of the plasma spraying process: during transfer in the volume of the gas stream and deformation at the moment of impact on the substrate. The effect of the change in current on the size of powder particles during their transfer through the high-temperature stream and the degree of particle deformation upon impact with the substrate was determined. It was found that during transfer through the plasma jet, there was an increase in the average size of sputtering products by two–three times compared to the initial effects of mechanochemical synthesis due to the coagulation of some particles. In this case, an increase in current from 400 to 500 A led to a growth in average particle size by 14–47% due to the partial evaporation of fine particles with an increase in their heating degree. An increase in current also led to a 5–10% growth in particle deformation degree upon impact on the substrate due to the rising temperature and velocity of the plasma jet. Based on the research, the parameters of plasma spraying of mechanically synthesized Fe3Al intermetallic-based powders were determined, at which dense coatings with a thin-lamellar structure were formed.
In this article, the structure formation and phase composition of coatings containing Cr2AlC MAX phase under the conditions of plasma spraying were studied. Mechanical mixtures of commercially available Cr3C2 and Al powders were used as a material for spraying. The amount of aluminium in the mixtures was 9 and 18 wt.%. As a result of studying physicochemical processes occurring during plasma spraying of mechanical mixtures of selected compositions, the formation of coatings containing Cr2AlC MAX phase was established, the synthesis of which occurs both at the stage of the particles flight of initial components in the plasma jet as a result of the collision and coagulation, and at the stage of a coating layer formation as a result of layering particles deformed during the collision–splats. It is shown that for the formation of a denser coating with a higher MAX phase content for spraying, it is rational to use a mixture of chromium carbide powders with 9 wt.% of aluminium. A coating with the composition 91Cr3C2-9Al (wt.%) has high corrosion resistance in operation conditions in a chloride-acetate solution, and by its indicators of corrosion resistance, is not inferior to the Cr3C2-NiCr coating, which is widely used in industry to protect parts from corrosion and wear. The obtained results show the possibility and feasibility of using mechanical mixtures of commercially available powders for the formation of coatings containing Cr2AlC MAX phase instead of expensive synthesized MAX-Cr2AlC powders.
1 January 2024 in Transactions of Kremenchuk Mykhailo Ostrohradskyi National University