Optical absorption and emission experiments were used to characterize defects and defect aggregates in Mg-doped crystals due to thermochemical reduction at high temperatures. Oxygen vacancies and higher-order defects are produced much more readily in Mg-doped than in undoped crystals. and centers (oxygen vacancies with one or two electrons, respectively) were monitored by their optical absorption bands at about 4.8 and , respectively. In contrast with undoped crystals, where the reduction produces primarily centers and a small amount of centers, in Mg-doped crystals both and centers are created in comparable concentrations. These thermally generated and centers are much more stable than those produced in undoped crystals irradiated with neutrons. Clustering of individual oxygen vacancies forming higher-order defects, such as anion divacancy and centers, was investigated by low temperature absorption and luminescence experiments, in conjunction with UV irradiation and thermal treatments. The strong absorption bands at 2.87 and were shown to be due to Mg-perturbed and centers, respectively. In addition, photoconversion of and centers was observed. In crystals containing large concentrations of centers, electrons excited by light are trapped by and centers resulting in the conversion of centers into . A model of -type centers was extended to and centers. The calculated optical parameters are in very good agreement with those determined experimentally. A simple analysis of the lattice energy suggests that the environments of the -type centers are different in TCR crystals and in -irradiated undoped crystals.
The phenomenally large enhancement in conductivity observed when Li-doped MgO crystals are oxidized at elevated temperatures was investigated by dc and ac electrical measurements in the temperature interval 250–673 K. The concentration of centers (substitutional ions each with a trapped hole) resulting from oxidation was monitored by optical absorption measurements. At low electric fields, dc measurements reveal blocking contacts. At high fields, the characteristic is similar to that of a diode connected in series with the bulk resistance of the sample. Low-voltage ac measurements show that the equivalent circuit for the sample consists of the bulk resistance in series with the junction capacitance connected in parallel with a capacitance, which represents the dielectric constant of the sample. Both dc and ac experiments provide consistent values for the bulk resistance. The electrical conductivity of oxidized MgO:Li crystals increases linearly with the concentration of centers. The conductivity is thermally activated with an activation energy of which is independent of the content. The standard semiconducting mechanism satisfactorily explains these results. Free holes are the main contribution to band conduction as they are released from the -acceptor centers. In as-grown MgO:Li crystals (without centers) the electrical current increases with time as centers are being formed. When ample centers are formed, an activation energy of 0.7 eV was observed. At sufficiently high current, Joule heating thermally destroys the centers.
1 May 2002 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
Direct current and alternating current electrical measurements were performed to investigate the electrical conductivity of samples with different concentrations of centers (Mg ions each with a trapped hole) in the temperature interval 250–800 K. The concentration of centers was monitored by the optical absorption peak at 2.56 eV. These centers were produced by oxidation at temperatures above 1050 K. The formation rate of centers depends on the previous thermal history of the sample in either reducing or oxidizing atmosphere. At low electrical fields, dc measurements reveal blocking contacts. At high fields, the characteristic is similar to that of a diode (corresponding to a blocking contact at one side of the sample and an ohmic contact at the other side) connected in series with the bulk resistance of the sample. Steady electroluminescence is emitted at the negative electrode when a current in excess of ≈10 μA passes through the sample, indicating that the majority of carriers are holes. Low voltage ac measurements show that the equivalent circuit for the sample is the bulk resistance in series with the junction capacitance (representing the blocking contacts) connected in parallel with a capacitance, which represents the dielectric constant of the sample. The values determined for the bulk resistance in both dc and ac experiments are in good agreement. The electrical conductivity of crystals increases linearly with the concentration of centers, regardless of the amount of other impurities also present in the crystals, and is four times higher in the than in the direction. The conductivity is thermally activated with an activation energy of 0.68 eV, which is independent of: (1) the content, (2) the crystallographic orientation, and (3) the concentration of other impurities. These results favor the small-polaron-motion mechanism.
In the temperature interval 300–773 K, ac and dc electrical measurements show a phenomenally large enhancement of the electrical conductivity of otherwise excellent insulator crystals when doped with magnesium impurities. The conductivity increases linearly with the concentration of hole-trapped centers and is four times higher in the direction parallel to the crystallographic c axis than in the perpendicular direction. The conductivity activation energy is 0.68 eV, independent of both content and crystallographic orientation. Electroluminescence experiments indicate that holes are the majority carriers. These results favor the small-polaron-motion mechanism.