Off-road vehicles used in construction and agricultural activities can contribute substantially to emissions of gaseous pollutants and can be a major source of submicrometer carbonaceous particles in many parts of the world. However, there have been relatively few efforts in quantifying the emission factors (EFs) and for estimating the potential emission reduction benefits using emission control technologies for these vehicles. This study characterized the black carbon (BC) component of particulate matter and NOx, CO, and CO2 EFs of selected diesel-powered off-road mobile sources in Mexico under real-world operating conditions using on-board portable emissions measurements systems (PEMS). The vehicles sampled included two backhoes, one tractor, a crane, an excavator, two front loaders, two bulldozers, an air compressor, and a power generator used in the construction and agricultural activities. For a selected number of these vehicles the emissions were further characterized with wall-flow diesel particle filters (DPFs) and partial-flow DPFs (p-DPFs) installed. Fuel-based EFs presented less variability than time-based emission rates, particularly for the BC. Average baseline EFs in working conditions for BC, NOx, and CO ranged from 0.04 to 5.7, from 12.6 to 81.8, and from 7.9 to 285.7 g/kg-fuel, respectively, and a high dependency by operation mode and by vehicle type was observed. Measurement-base frequency distributions of EFs by operation mode are proposed as an alternative method for characterizing the variability of off-road vehicles emissions under real-world conditions. Mass-based reductions for black carbon EFs were substantially large (above 99%) when DPFs were installed and the vehicles were idling, and the reductions were moderate (in the 20–60% range) for p-DPFs in working operating conditions. The observed high variability in measured EFs also indicates the need for detailed vehicle operation data for accurately estimating emissions from off-road vehicles in emissions inventories. Implications: Measurements of off-road vehicles used in construction and agricultural activities in Mexico using on-board portable emissions measurements systems (PEMS) showed that these vehicles can be major sources of black carbon and NOX. Emission factors varied significantly under real-world operating conditions, suggesting the need for detailed vehicle operation data for accurately estimating emissions inventories. Tests conducted in a selected number of sampled vehicles indicated that diesel particle filters (DPFs) are an effective technology for control of diesel particulate emissions and can provide potentially large emissions reduction in Mexico if widely implemented.
22 February 2019 in Air Quality, Atmosphere & Health
Agricultural burning is still a common practice around the world. It is associated with the high emission of air pollutants, including short-term climate change forcing pollutants such as black carbon and PM2.5. The legal requirements to start any regulatory actions to control them is the identification of its area of influence. However, this task is challenging from the experimental and modeling point of view, since it is a short-term event with a moving area source of pollutants. In this work, we assessed this agricultural burning influence-area using the US Environmental authorities recommended air dispersion model (AERMOD). We considered different sizes and geometries of burning areas located on flat terrains, and several crops burning under the worst-case scenario of meteorological conditions. The influence area was determined as the largest area where the short-term concentrations of pollutants (1 h or one day) exceed the local air quality standards. We found that this area is a band around the burning area whose size increases with the burning rate but not with its size. Finally, we suggested alternatives of public policy to regulate this activity, which is based on limiting the burning-rate in the way that no existing households remain inside the resulting influence-area. However, this policy should be understood as a transition towards a policy that forbids agricultural burning.
Aiming to advance in the understanding of pollutant dispersion near arterial roads, we measured, simultaneously, meteorological parameters, emission mass rates and TSP, PM10 and PM2.5 concentrations at several locations downwind two roads, located on a flat region without any other source of pollutants. We also implemented on a state of the art commercial CFD software, an air quality model to simulate the dispersion of solid and gas-phase pollutants emitted from arterial roads. Numerical results of long-term averages and daily measurements of particle concentration showed high correlation with experimental measurements (R2 > 0.76). We found that the plots of pollutants concentration vs distance to the road edge describe a unique curve when expressed in terms of non-dimensional numbers and that this curve is well described by a beta function. Profiles of vertical concentration sketch an exponential function at the road edge, an S shape downwind and a flat shape far from the road. Particles exhibit a Rosin Rambler size distribution with average diameter of ~ 7 μm. This distribution remains unaltered downwind from the road, which implies that at any location, PM10 and PM2.5 concentrations are a constant fraction of TPS concentration. Experimental data confirmed this observation. Previous results can be used to determine the size of the area impacted by roads, identify mitigating and adaptive countermeasures, and to improve the accuracy of vehicular emission factors.
21 April 2025 in Journal of the Operational Research Society