Direct study of CO2 capture efficiency during microalgae Arthrospira platensis cultivation at high CO2 concentrations was carried out. Microalgae were grown in a 90 L photobioreactor on Zarrouk’s medium prepared with distilled water. Three 15-day experiments were carried out with different initial CO2 concentrations: 1, 5, and 9 vol.%. During the experiments, both the change in the optical density of the microalgae suspension and the direct change in the CO2 concentration in the chamber were measured. The maximum decrease in CO2 concentration due to the growth of microalgae was 0.10 vol.% (CO2)/day in the experiment with an initial CO2 concentration of 5 vol.%. Growth rate of biomass density was 79.4, 76.3, and 48.4 (mg/L)/day at 1, 5, and 9 vol.% CO2 concentrations, respectively. During the experiment with initial CO2 concentrations of 1 and 5 vol.%., pH of the culture medium was increased, but pH was decreased from 9.2 to 8.8 at 9 vol.%. In general, good viability (high quality of biomass and high rate of its growth) of Arthrospira platensis was established at 1 and 5 vol. (CO2)%, while massive death of Arthrospira platensis cells was observed in the experiment with 9 vol. (CO2)%. Biochemical analysis of the resulting biomass revealed a decrease in the content of lipids and proteins with an increase in CO2 concentration.
The demand for natural foods with high protein content and functional properties is constantly growing in the last years. In this context, microalgae as Spirulina (Arthrospira spp.), Chlorella spp., Haematococcus pluvialis, Dunaliella salina, and others, assume a key role to diversify the offer of nutritious and functional ingredients and supplements. Microalgae are commercialized, mostly, as dried powders to facilitate their use as food ingredients and to allow easy transportation and long-term stability. Microalgal powder quality and storage stability depend mainly on drying method, packaging, and storage conditions. Most of the studies that approach the subject of microalgal drying evaluate the efficiency of the process and suitability for this raw material. However, studies that assess the effect of traditional and innovative drying methods on quality of microalgal powder for human consumption are rare in literature. In this chapter, the state of the art of drying processing technology for microalgae was reviewed, discussing the effect of dehydration on quality and stability of microalgal powders with potential use in human alimentation.
This study evaluated productivity, CO2 biofixation, and lipid content in biomass of the acidophilic microalga Chlamydomonas acidophila LAFIC-004 cultivated with five different carbon dioxide concentrations. The influence of carbon dioxide concentration on nutrient removal and pH was also investigated. Treated wastewater (secondary effluent) was used as culture medium. Five experimental setups were tested: T-0% – injection of atmospheric air (0.038% CO2), T-5% (5% CO2), T-10% (10% CO2), T-15% (15% CO2) and T-20% (20% CO2). The T-5% and T-10% experiments showed the highest values of productivity and CO2 biofixation, and maximum biomass dry weight was 0.48 ± 0.02 and 0.51 ± 0.03 g L−1, respectively. This acidophilic microalga proved to be suitable for carbon biofixation and removal of nutrients from secondary effluent of wastewater treatment plants with high CO2 concentration. All assays were performed without pH control. This microalga species presented high lipid content. However, fatty acid methyl esters (FAME) are not suitable for biodiesel use. GRAPHICAL ABSTRACT