This study focuses on the effect of part geometry and infill degrees on effective mechanical properties of extrusion additively manufactured stainless steel 316L parts produced with BASF’s Ultrafuse 316LX filament. Knowledge about correlations between infill degrees, mechanical properties and dimensional deviations are essential to enhance the part performance and further establish efficient methods for the product development for lightweight metal engineering applications. To investigate the effective Young’s modulus, yield strength and bending stress, standard testing methods for tensile testing and bending testing were used. For evaluating the dimensional accuracy, the tensile and bending specimens were measured before and after sintering to analyze anisotropic shrinkage effects and dimensional deviations linked to the infill structure. The results showed that dimensions larger than 10 mm have minor geometrical deviations and that the effective Young’s modulus varied in the range of 176%. These findings provide a more profound understanding of the process and its capabilities and enhance the product development process for metal extrusion-based additive manufacturing.
This study focuses on an epoxy novolac-based hot-melt prepreg resin system cured with dicyandiamide for purpose of aircraft interiors. The influence of the phosphorus-based reactive flame retardant 9,10-dihydro-9-oxa-10-phos-phaphenanthrene-10-oxide (DOPO) as a function of its concentration on the flammability behaviour of the cured neat resin is investigated by UL 94 testing. Besides this, the efficiency of boehmite as synergistic flame retardant is examined at two levels of DOPO content. The effect of the specific flame retardants on the mechanical properties of the cured resin formulations is evaluated by tensile and fracture toughness testing. Glass transition temperatures are measured using dynamic mechanical analysis. It is shown that the flame retardancy is significantly improved with increasing phosphorus content whereas the glass transition temperature decreases. The fracture toughness is not affected within the considered range of phosphorus content. The addition of boehmite to the modified resins leads to further improvement in flame-retardant behaviour. Moreover, it is presented that the fracture toughness increases with higher content of this mineral microfiller while the elongation at break is not lowered for boehmite loadings up to approximately 25 wt.%.