Digital twins of industrial and collaborative robots are widely used to evaluate and predict the behavior of manipulators under different control strategies. However, these digital twins often employ simplified mathematical models that do not fully describe their dynamics. In this paper, we present the design of a high-fidelity digital twin of a six degrees-of-freedom articulated robot using Simscape Multibody, a Matlab toolbox that allows the design of robotic manipulators in a rather intuitive and user-friendly manner. This robot digital twin includes joint friction, transmission gears, and electric actuators dynamics. After assessing the dynamic accuracy of the Simscape model, we used it to test a computed torque control scheme, proving that this model can be reliably used in simulations with different aims, such as validating control schemes, evaluating collaborative functions or minimizing power consumption.
23 February 2024 in The International Journal of Advanced Manufacturing Technology
Robot positioning accuracy is a key factory when performing high-precision manufacturing tasks. To effectively improve the accuracy of a manipulator, often up to a value close to its repeatability, calibration plays a crucial role. In the literature, various approaches to robot calibration have been proposed, and they range considerably in the type of measurement system and identification algorithm used. Our aim was to develop a novel step-by-step kinematic calibration procedure — where the parameters are subsequently estimated one at a time — that only uses 1D distance measurement data obtained through a draw-wire encoder. To pursue this objective, we derived an analytical approach to find, for each unknown parameter, a set of calibration points where the discrepancy between the measured and predicted distances only depends on that unknown parameter. This reduces the computational burden of the identification process while potentially improving its accuracy. Simulations and experimental tests were carried out on a 6 degrees-of-freedom robot arm: the results confirmed the validity of the proposed strategy. As a result, the proposed step-by-step calibration approach represents a practical, cost-effective and computationally less demanding alternative to standard calibration approaches, making robot calibration more accessible and easier to perform.
The automation of bin-picking processes has been a research topic for almost two decades. General-purpose equipment, however, still does not show adequate success rates to find application in most industrial tasks. Human–robot collaboration in bin–picking tasks can increase the success rate by exploiting human perception and handling skills and the robot ability to perform repetitive tasks. The aim of this paper, starting from a general-purpose industrial bin picking equipment comprising a 3D–structured light vision system and a collaborative robot, consists in enhancing its performance and possible applications through human–robot collaboration. To achieve successful and fluent human–robot collaboration, the robotic workcell must meet some hardware and software requirements that are defined below. The proposed strategy is tested in some sample tests: the results of the experimental tests show that collaborative functions can be particularly useful to overcome typical bin picking failures and to improve the fault tolerance of the system, increasing its flexibility and reducing downtimes.
22 August 2025 in Journal of Intelligent & Robotic Systems
This paper presents a comprehensive approach to dynamic modeling and parameter identification for SCARA robots. The focus is on accurately capturing nonlinear friction and coupling effects, which are frequently inadequately addressed in standard modeling and identification techniques. A novel two-step identification procedure is proposed, where friction parameters are identified independently from inertial parameters. This decoupled approach allows for a more accurate representation of friction behavior, especially at low velocities. Additionally, the influence of ball screw spline coupling between joints 3 and 4 is investigated, revealing its impact on the robot’s dynamics, particularly under payload conditions. The identified dynamic model is validated through both standard torque prediction and model-based control. Experimental results demonstrate the superiority of the proposed approach over traditional methods, leading to significantly improved torque prediction accuracy and enhanced tracking performance in model-based control.