Sameh Assem Ibrahim

Prof. Dr. Sameh Assem Ibrahim

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 May 2011 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
SISameh Assem Ibrahim
Sameh Assem Ibrahim
BRBehzad Razavi
Behzad Razavi
The power consumption of wireline circuits has become increasingly more critical as the pin count and data rate rise. This paper describes a power scaling methodology and a new half-rate speculative architecture for decision-feedback equalizers (DFEs) to relax the speed-power trade-offs. Designed in 90-nm CMOS technology, a 20-Gb/s prototype consisting of a linear equalizer and a one-tap DFE compensates for the loss of an 18-in FR4 trace while drawing 40 mW from a 1-V supply.

7 February 2020 in Multimedia Tools and Applications
Verified
Journal Article
Closed access
PDF file
LELamiaa A. Abou Elazm
Lamiaa A. Abou Elazm
SISameh Assem Ibrahim
Sameh Assem Ibrahim
MEMohamed G. Egila
Mohamed G. Egila
HSH. Shawky
H. Shawky
MEMohamed K. H. Elsaid
Mohamed K. H. Elsaid
FEFathi Abd El-Samie
Fathi Abd El-Samie

16 May 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
AMAhmed M. Mohey
Ahmed M. Mohey
SISameh Assem Ibrahim
Sameh Assem Ibrahim
IHIsmail M. Hafez
Ismail M. Hafez
HyungWon KimHyungWon Kim
HyungWon Kim
Low-power circuits often employ dynamic voltage scaling and energy harvesting. Such circuits need a power management unit that can convert the voltage source to a wide range of target voltages with high efficiency. Targeting such a power management unit, this paper presents a reconfigurable architecture of switched capacitor (SC) voltage converter. It introduces a design optimization methodology that can determine trade-off among design parameters to meet the goal. The proposed converter employs a reconfigurable topology with four capacitors. It provides 11 conversion ratios: 6 stepdown and 5 step-up ratios supporting wide input/output voltage range. An analytical model for the output impedance of the proposed reconfigurable SC topology is presented. Using the model, the proposed optimization methodology can minimize the total power dissipation. To validate the proposed architecture and optimization methodology, the converter has been implemented in a 130-nm CMOS process using integrated capacitors of total size 2.2 nF. Simulation results show that the optimized converter circuit achieves an efficiency range from 83.41% to 74.69% for a load current of 100 μA.

27 March 2017 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
ASAhmed Saeed
Ahmed Saeed
SISameh Assem Ibrahim
Sameh Assem Ibrahim
HRHani Fikry Ragai
Hani Fikry Ragai
A novel sizing methodology for Dickson charge pumps with pure capacitive loads is presented. The methodology is based on dynamic analysis to minimize the rise time of the charge pump up to 25% under a given circuit area. The methodology is validated through the implementation of a six-stage charge pump-based driver in 180-nm standard low-voltage CMOS technology. The driver is used for the excitation of ultrasonic transducers with 34 V at a resonance frequency of 220 KHz. A rise time of only 512 nS is achieved. The driver consumes 10.6 mA drawn from a 5-V supply at a pumping frequency of 50 MHz and occupies an area of 0.2 mm2.

11 August 2016
Verified
Conference Paper
Closed access
AAAya G. Amer
Aya G. Amer
SISameh Assem Ibrahim
Sameh Assem Ibrahim
HRHani Fikry Ragai
Hani Fikry Ragai
A charge pump circuit to minimize current mismatch and current variation over a wide voltage compliance range is proposed. A feedback loop is used to cancel both deterministic and random mismatches between charging and discharging current to minimize PLL reference spurs and static phase offset. A current compensation circuit is used to minimize current variation to avoid bandwidth variation and loop instability. The circuit can operate at low supply voltage. The power overhead due to added circuitry is 3.36% making it suitable for low-power and low-voltage applications. The proposed current-steering charge pump circuit achieves mismatch lower than 0.44% over the output voltage range from 0.06 V to 0.85 V. Also the current variation is reduced to less than 1.19% when the output voltage varies from 0.06 V to 0.85 V in the 65 nm CMOS process with 1 V supply.

1 December 2016
Verified
Conference Paper
Closed access
MAMostafa M. Ayesh
Mostafa M. Ayesh
SISameh Assem Ibrahim
Sameh Assem Ibrahim
MAMohamed M. Aboudina
Mohamed M. Aboudina
This paper presents an ultra low-power high-speed dynamic comparator. The proposed dynamic comparator is designed and simulated in a 65-nm CMOS technology. It dissipates 7 μW, 21.1 μW from a 0.9-V supply while operating at 1 GHz, 3 GHz sampling clock respectively. Proposed circuit can work up to 14 GHz. Ultra low power consumption is achieved by utilizing charge-steering concept and proper sizing. Monte Carlo simulations show that the input referred offset contribution of the internal devices is negligible compared to the effect of the input devices which results in 3.8 mV offset and 3 mV kick-back noise.