Turbines are one of the most important means of producing clean energy, as they do not cause any negative emissions affecting the environment. Recently, the need to design turbines capable of facing strong winds has appeared because the currently designed turbines must be cut off in such circumstances. This study aims to find the best design parameters and investigate the efficiency of the jet turbine at high wind speed conditions. SolidWorks and MatLab are used to design and analyze small jet wind turbines. The design parameters were chosen to obtain the best efficiency. The turbine diameter is 0.5 m, and the short blade length helps withstand the generated stresses due to strong wind, especially fatigue stress, and resists bending. Blade pitch angle beta starts from 2° from the vertical axis at the hub and changes harmonically along the length to end at an angle of 88° at the blade’s tip to allow air to pass through and not form a wall. The blade number has chosen 15 blades, corresponding to the Betz limit, to obtain the maximum power coefficient. As a result, the assigned power was obtained at a wind speed of 28 m/s. At a lower wind speed, it will work with acceptable efficiency and more efficiently at higher speeds. Therefore, this turbine is suitable to use in such cases.
30 September 2023 in Bulletin of L.N. Gumilyov Eurasian National University. Technical Science and Technology Series
Global warming is a serious challenge to civilizational development due to the increase in temperature because of exhaust gases. These gases, produced by burning fossil fuels, should reduce or replace the way energy is generated using renewable energy sources. Our study shows the ability of 1.5-meter reduce wind turbine to create a mechanical power to drive some mechanical devices under high wind speed conditions. This type of devices needs approximately 1460 watt (2 horses); the turbine designed with angle blade Beta 2 degrees and Lambda 10 to reach maximum benefit from the wind. The turbine is exposed to variable wind, as a result, the turbine generates the required power when the wind speed is from 9.3 to 9.7 m/s, when the generated power is less than the required one, the device can work with less efficiency, and more power is better within the limits that do not damage device.
1 February 2021 in IOP Conference Series: Materials Science and Engineering
This paper numerically and experimentally examines the natural frequencies and mode shapes in a satellite model-plate connecting interface installed on flexible gas-inflated jacks in order to assess the effect of external impacts on the natural frequencies of the satellite model and to thus generate a reference for appropriate vibration isolators for transportation and launch as required. The experimental determination of the frequencies and mode shapes of vibration in the system was carried out using modern software in conjunction with the hardware loading model satellite (LMS). Numerical calculation of the natural frequencies and mode shapes of the research object was performed in the finite element package ANSYS Workbench, with results suggesting that the suspension system (gas inflatable jacks) was sufficiently flexible and did not affect the natural frequencies at which the system under investigation, the satellite model-connecting interface plate, began to deform. Experimental determination of the natural frequencies and mode shapes of vibration for the satellite model-connecting interface plate was then conducted in the range from 44 Hz to 200 Hz; the differences in natural frequencies between the calculations and experiments averaged 10 to 15%.