Squeezing out efficient thermoelectrics: Thermoelectric materials hold the promise of converting waste heat into electricity. The challenge is to develop high-efficiency materials that are not too expensive. Kim et al. suggest a pathway for developing inexpensive thermoelectrics. They show a dramatic improvement of efficiency in bismuth telluride samples by quickly squeezing out excess liquid during compaction. This method introduces grain boundary dislocations in a way that avoids degrading electrical conductivity, which makes a better thermoelectric material. With the potential for scale-up and application to cheaper materials, this discovery presents an attractive path forward for thermoelectrics. Science , this issue p. 109

Printing techniques could offer a scalable approach to fabricate thermoelectric (TE) devices on flexible substrates for power generation used in wearable devices and personalized thermo-regulation. However, typical printing processes need a large concentration of binder additives, which often render a detrimental effect on electrical transport of the printed TE layers. Here, we report scalable screen-printing of TE layers on flexible fiber glass fabrics, by rationally optimizing the printing inks consisting of TE particles (p-type Bi_0.5Sb_1.5Te₃ or n-type Bi₂Te_2.7Se_0.3), binders, and organic solvents. We identified a suitable binder additive, methyl cellulose, which offers suitable viscosity for printability at a very small concentration (0.45–0.60 wt.%), thus minimizing its negative impact on electrical transport. Following printing, the binders were subsequently burnt off via sintering and hot pressing. We found that the nanoscale defects left behind after the binder burnt off became effective phonon scattering centers, leading to low lattice thermal conductivity in the printed n-type material. With the high electrical conductivity and low thermal conductivity, the screen-printed TE layers showed high room-temperature ZT values of 0.65 and 0.81 for p-type and n-type, respectively.