Silicon is a promising next-generation anode to increase energy density over commercial graphite anodes, but calendar life remains problematic. In this work, scanning electrochemical microscopy was used to track the site-specific reactivity of a silicon thin film surface over time to determine if undesirable Faradaic reactions were occurring at the formed solid electrolyte interphase (SEI) during calendar aging in four case scenarios: formation between 1.5 V and 100 mV with subsequent rest starting at (1) 1.5 V and (2) 100 mV and formation between 0.75 V and 100 mV with subsequent rest starting at (3) 0.75 V and (4) 100 mV. In all cases, the electrical passivation of silicon decreased with increasing time and potential relative to Li/Li+ over a 3 day period. Along with the decrease in passivation, the homogeneity of passivation over a 500 μm2 area decreased with time. Despite some local "hot spots" of reactivity, the areal uniformity of passivation suggests global SEI failure (e.g., SEI dissolution) rather than localized (e.g., cracking) failure. The silicon delithiated to 1.5 V vs Li/Li+ was less passivated than the lithiated silicon (at the beginning of rest, the forward rate constants, kf, for ferrocene redox were 7.19 × 10-5 and 3.17 × 10-7 m/s, respectively) and was also found to be more reactive than the pristine silicon surface (kf of 5 × 10-5 m/s). This reactivity was likely the result of SEI oxidation. When the cell was only delithiated up to 0.75 V versus Li/Li+, the surface was still passivating (kf of 6.11 × 10-6 m/s), but still less so than the lithiated surface (kf of 3.03 × 10-9 m/s). This indicates that the potential of the anode should be kept at or below ∼0.75 V vs Li/Li+ to prevent decreasing SEI passivation. This information will help with tuning the voltage windows for prelithiation in Si half cells and the operating voltage of Si full cells to optimize calendar life. The results provided should encourage the research community to investigate chemical, rather than mechanical, modes of failure during calendar aging and to stop using the typical convention of 1.5 V as a cutoff potential for cycling Si in half cells.
Advances in targeted α-therapies have increased the interest in actinium (Ac), whose chemistry is poorly defined due to scarcity and radiological hazards. Challenges associated with characterizing Ac3+ chemistry are magnified by its 5f06d0 electronic configuration, which precludes the use of many spectroscopic methods amenable to small amounts of material and low concentrations (like EPR, UV–vis, fluorescence). In terms of nuclear spectroscopy, many actinium isotopes (225Ac and 227Ac) are equally “unfriendly” because the actinium α-, β-, and γ-emissions are difficult to resolve from the actinium daughters. To address these issues, we developed a method for isolating an actinium isotope (228Ac) whose nuclear properties are well-suited for γ-spectroscopy. This four-step procedure isolates 228Ra from naturally occurring 232Th. The relatively long-lived 228Ra (t1/2 = 5.75(3) years) radioisotope subsequently decays to 228Ac. Because the 228Ac decay rate [t1/2 = 6.15(2) h] is fast, 228Ac rapidly regenerates after being harvested from the 228Ra parent. The resulting 228Ac generator provides frequent and long-term access (of many years) to the spectroscopically “friendly” 228Ac radionuclide. We have demonstrated that the 228Ac product can be routinely “milked” from this generator on a daily basis, in chemically pure form, with high specific activity and in excellent yield (∼95%). Hence, in the same way that developing synthesis routes to new starting materials has advanced coordination chemistry for many metals by broadening access, this 228Ac generator has the potential to broaden actinium access for the inorganic community, facilitating the characterization of actinium chemical behavior.