Melissa L. Meyerson

Dr. Melissa L. Meyerson

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 October 2023 in Nano Letters
Verified
Journal Article
Closed access
THTerefe G. Habteyes
Terefe G. Habteyes
EWEric R. Westphal
Eric R. Westphal
KPKenneth M. Plackowski
Kenneth M. Plackowski
PKPaul G. Kotula
Paul G. Kotula
MMMelissa L. Meyerson
Melissa L. Meyerson
JGJohn Grey
John Grey

27 July 2023 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
LSLeo J. Small
Leo J. Small
SVSimon M. Vornholt
Simon M. Vornholt
SPStephen J. Percival
Stephen J. Percival
MMMelissa L. Meyerson
Melissa L. Meyerson
MSMara E. Schindelholz
Mara E. Schindelholz
TNTina Nenoff
Tina Nenoff

5 April 2024 in ACS Applied Materials & Interfaces
Verified
Journal Article
Open access
JMJosefine D. McBrayer
Josefine D. McBrayer
NSNoah Schorr
Noah Schorr
MLMila Nhu Lam
Mila Nhu Lam
MMMelissa L. Meyerson
Melissa L. Meyerson
KHKatharine L. Harrison
Katharine L. Harrison
SMShelley Minteer
Shelley Minteer
Silicon is a promising next-generation anode to increase energy density over commercial graphite anodes, but calendar life remains problematic. In this work, scanning electrochemical microscopy was used to track the site-specific reactivity of a silicon thin film surface over time to determine if undesirable Faradaic reactions were occurring at the formed solid electrolyte interphase (SEI) during calendar aging in four case scenarios: formation between 1.5 V and 100 mV with subsequent rest starting at (1) 1.5 V and (2) 100 mV and formation between 0.75 V and 100 mV with subsequent rest starting at (3) 0.75 V and (4) 100 mV. In all cases, the electrical passivation of silicon decreased with increasing time and potential relative to Li/Li+ over a 3 day period. Along with the decrease in passivation, the homogeneity of passivation over a 500 μm2 area decreased with time. Despite some local "hot spots" of reactivity, the areal uniformity of passivation suggests global SEI failure (e.g., SEI dissolution) rather than localized (e.g., cracking) failure. The silicon delithiated to 1.5 V vs Li/Li+ was less passivated than the lithiated silicon (at the beginning of rest, the forward rate constants, kf, for ferrocene redox were 7.19 × 10-5 and 3.17 × 10-7 m/s, respectively) and was also found to be more reactive than the pristine silicon surface (kf of 5 × 10-5 m/s). This reactivity was likely the result of SEI oxidation. When the cell was only delithiated up to 0.75 V versus Li/Li+, the surface was still passivating (kf of 6.11 × 10-6 m/s), but still less so than the lithiated surface (kf of 3.03 × 10-9 m/s). This indicates that the potential of the anode should be kept at or below ∼0.75 V vs Li/Li+ to prevent decreasing SEI passivation. This information will help with tuning the voltage windows for prelithiation in Si half cells and the operating voltage of Si full cells to optimize calendar life. The results provided should encourage the research community to investigate chemical, rather than mechanical, modes of failure during calendar aging and to stop using the typical convention of 1.5 V as a cutoff potential for cycling Si in half cells.

7 April 2022 in ACS Applied Energy Materials
Verified
Journal Article
Open access
MMMelissa L. Meyerson
Melissa L. Meyerson
SRSamantha G. Rosenberg
Samantha G. Rosenberg
LSLeo J. Small
Leo J. Small
Lithium–sulfur is a “beyond-Li-ion” battery chemistry attractive for its high energy density coupled with low-cost sulfur. Expanding to the MWh required for grid scale energy storage, however, requires a different approach for reasons of safety, scalability, and cost. Here we demonstrate the marriage of the redox-targeting scheme to the engineered Li solid electrolyte interphase (SEI), enabling a scalable, high efficiency, membrane-less Li–S redox flow battery. In this hybrid flow battery architecture, the Li anode is housed in the electrochemical cell, while the solid sulfur is safely kept in a separate catholyte reservoir and electrolyte is pumped over the sulfur and into the electrochemical cell. Electrochemically facile decamethylferrocene and cobaltocene are chosen as redox mediators to kick-start the initial reduction of solid S into soluble polysulfides and final reduction of polysulfides into solid Li2S, precluding the need for conductive carbons. On the anode side, a LiI and LiNO3 pretreatment strategy encourages a stable SEI and lessens capacity fade, avoiding use of ion-selective separators. Complementary materials characterization confirms the uniform distribution of LiI in the SEI, while SEM confirms the presence of lower surface area globular Li deposition and UV–vis corroborates evolution of the polysulfide species. Equivalent areal loadings of up to 50 mgS cm–2 (84 mAh cm–2) are demonstrated, with high capacity and voltage efficiency at 1–2 mgS cm–2 (973 mAh gS–1 and 81.3% VE in static cells and 1142 mAh gS–1 and 86.9% VE in flow cells). These results imply that the fundamental Li–S chemistry and SEI engineering strategies can be adapted to the hybrid redox flow battery architecture, obviating the need for ion-selective membranes or flowing carbon additives, and offering a potential pathway for inexpensive, scalable, and safe MWh scale Li–S energy storage.

17 January 2023 in The Journal of Physical Chemistry C
Verified
Journal Article
Open access
AMAdam M. Maraschky
Adam M. Maraschky
MMMelissa L. Meyerson
Melissa L. Meyerson
SPStephen J. Percival
Stephen J. Percival
DLDaniel R. Lowry
Daniel R. Lowry
SMStephen Meserole
Stephen Meserole
ESErik D. Spoerke
Erik D. Spoerke

24 May 2024 in Thin Solid Films
Verified
Journal Article
Closed access
MFMina Faltas
Mina Faltas
JPJamin Pillars
Jamin Pillars
LSLuke Soule
Luke Soule
MMMelissa L. Meyerson
Melissa L. Meyerson
MRMark A. Rodriguez
Mark A. Rodriguez
IEIhab El-Kady
Ihab El-Kady