To study the influence of the laser power, scanning speed, and cleaning water content on the laser cleaning effect and obtain the best cleaning parameters, this paper conducted a simulation analysis of the laser cleaning process and carried out a pulse laser cleaning of porcelain insulators experiment to verify. The results show that the cleaning rate gradually increases as the laser power increases from 20 W to 25 W. As the scanning speed increases from 1000 mm/s to 2500 mm/s, the laser overlapping rate gradually decreases, and the cleaning takes the lead in increasing and then decreasing. The appropriate cleaning water content is conducive to laser cleaning; when the water content is 0.115 g, the cleaning efficiency reaches the highest value of 98.20%. When the laser power is 25 W, and the scanning speed is 2000 mm/s, the cleaning efficiency can reach the highest value of 96.87%. This paper shows that the reasonable choice of cleaning parameters can effectively clean the insulator surface filth and obtain a better surface morphology.

Detecting defects in grounded flat steel is essential for ensuring the safety and reliability of transmission tower grounding devices. However, traditional inspection methods, such as physical excavation and verification, are costly and time-consuming. This paper proposes a corrosion defect detection method for flat steel transmission tower grounding devices based on electromagnetic ultrasonic SH waves. In addition, using commercial software, a three-dimensional finite element simulation model of grounded flat steel with simulated pitting corrosion defects is constructed. The specified displacements applied to multiple surface sources mimic the horizontal shear vibrations generated by the electromagnetic ultrasonic transducer on the surface of the grounded flat steel during actual inspection. A simulation was used to investigate the propagation and attenuation characteristics of shear-horizontal ultrasonic SH0guided waves for simulated corrosion defects with various geometric configurations in grounded flat steel. The simulation investigated the propagation and attenuation characteristics of the SH0 wave in grounded flat steel and the detection of various defects for linear analysis of the results. The simulation results show that the attenuation of the electromagnetic ultrasonic guided wave is small, at only 0.0016 dB/mm, and the displacement amplitude of the echo signal decreases with the increase of the SH0 wave propagation distance. Increasing the depth and length of corrosion defects increases the echo signal amplitude. At the same time, the width of corrosion defects has little effect on the echo amplitude. Finally, a flat steel defect detection experiment was conducted, and the experimental results fit with the simulation to verify the accuracy of the simulation model. This detection method introduces a new idea for the on-site detection and quantitative identification of corrosion defects in grounded flat steel, which has significant reference value and can provide a more effective and economical method for ensuring the safety and dependability of transmission tower grounding devices.

When a pulsed laser cleans a glass insulator, the laser power, scanning speed, and repetition frequency affect the laser-cleaning effect. Herein, we considered glass insulators and their surface contaminations as objects, established a finite element model, analyzed the influence of these parameters on the temperature and stress fields, and explored the optimal cleaning parameters for glass insulator surface contamination. In addition, a laser test platform was constructed to verify the cleaning effect. The results indicated that the difference in the cleaning effect was negligible for lasers at repetition frequencies of 10–75 kHz. When the power increased, the scanning speed decreased and the temperature of the fouled layer increased. When the power was 60–70 W and the scanning speed was 240 mm/s, the equivalent tensile stress did not exceed the tensile strength of the insulator. The ablation reaction can remove the fouling part, and the tensile stress can overcome the adhesion force generated between the dirt and glass insulator to achieve effective cleaning. Experiments confirmed that the surface dirt removal rate of glass insulators can be approximately 99% at 60–70 W (laser power) and 240 mm/s (scanning speed).