Bidirectional single longitudinal mode fiber ring laser have advantages and potential in optical sensing, especially angular velocity sensing. The current methods for implementing bidirectional single longitudinal mode fiber ring laser cannot ensure complete reciprocity in the optical path, and the side mode suppression ratio needs to be increased, while the laser linewidth is relatively wide. This paper proposes a combined filtering structure using a bandpass filter and a cascaded add-drop type fiber ring filter. When realizing bidirectional single longitudinal mode output, the optical path structure is fully reciprocal including polarization state reciprocity, while the side mode suppression ratio is relatively high. The linewidth of the bidirectional laser is around 1.1kHz, far lower than the previous report of tens of kHz. The fully reciprocal combined filter structure proposed in this paper does not require special devices, and its theoretical system is mature, which is conducive to the subsequent application and improvement of bidirectional single longitudinal mode fiber ring laser.
The application of a bidirectional laser requires the laser intensity in both directions to be balanced. However, the CW and CCW light intensities in current bidirectional erbium-doped fiber laser experiments differ due to the gain competition effect. There is no report on equalizing the intensity in the CW and CCW directions. This paper proposes a bidirectional non-reciprocal optical attenuator using the Faraday optical rotation effect. Continuous attenuation adjustment is realized by changing the angle between the polarizer’s transmission axis and the linear polarized light. In this study, we analyzed the influence of different parameters on the device’s performance, built a non-reciprocal attenuator, and tested the bidirectional attenuation curve, which was consistent with the simulation results. The device was integrated into a bidirectional fiber laser, and the light intensity in both directions was balanced through non-reciprocal adjustment. Combined with closed-loop control, the average intensity difference fluctuation between the two directions was controlled at 0.28% relative to the average power, realizing stable long-term bidirectional fiber laser intensity equalization.
High-speed permanent magnet brushless dc (PM BLDC) motors rotor is typically protected with a nonmagnetic retaining sleeve. In this paper, a composite sleeve structure with an inner layer of titanium alloy and an outer layer of carbon fiber is designed. It is mechanically robust and present low eddy current loss with the new sleeve. In addition, eddy current loss and torque might be significant in the rotor of a PM BLDC motor and are comparatively analyzed by modifying the thickness of both materials of the new sleeve. After that, to address the problem of increased eddy current losses in PM due to the new sleeve, a composite sleeve with copper shielding is investigated. For the composite sleeve with a copper shield, the effects of the copper shield’s positions and thickness on the rotor losses are studied. Finally, the range of preferred composite sleeve structures is summarized.