The achievable grinding fineness of spiral jet mills does not only depend on the comminution efficiency in the region of the nozzle jets but is also significantly affected by the separation efficiency in the region of the product outlet. Therefore, the aim of this study is to investigate the influences of the product outlet diameter and different particle trap rings on the flow conditions and the grinding performance, optimizing the classifying efficiency of spiral jet mills. The velocity fields analyzed by particle image velocimetry and the experimental grinding results show that the classification process can be optimized by both reducing the product outlet diameter and installing a particle trap ring.
Spiral jet mills used for fine and colloid grinding have an enormously high energy consumption resulting in a great potential for optimization. In order to increase their efficiency, it is essential to precisely understand the flow conditions within the grinding chamber and the influencing parameters. In this work, the experimental method of particle image velocimetry is applied, which is optimized to the extent that the velocity fields of the grinding gas flow can be determined in the entire mill cross-section. Additionally, the influence of the product outlet diameter and the grinding gas flow rate on the flow profiles are investigated. With decreasing outlet diameter, significantly higher velocities are obtained in the inner mill region resulting in higher classifying efficiencies. At the same time, as the outlet diameter declines, an overpressure builds up in the mill, causing a deceleration of the entire flow in the outer region, preventing the complete formation of the nozzle jets and leading to worse comminution efficiencies. Therefore, there is an optimum between the competing comminution and classifying processes regarding the effect of the product outlet diameter. In contrast, increasing the gas flow rate can consistently achieve a gain in velocity, improving both comminution and classifying efficiency.
The processes occurring inside a spiral jet mill are significantly influenced by the flow conditions within the grinding chamber. As part of this work, an experimental 3D model of the grinding gas flow is successfully developed for the first time based on the results of PIV measurements. This model demonstrates the typical spiral vortex flow superimposed by the nozzle jets, as well as the characteristic comminution and classifying zones. In addition, the three-dimensional analysis of the nozzle jet enables the first experimental validation of the theoretical assumption proposed in the literature that the flow dynamics in this region can be described by Abramovich’s nozzle jet model. The vortex pair located on the back of the nozzle jet essentially contributes to the formation of the kidney-shaped flow cross-section of the nozzle jet. The two vortices are verified both by the flow dynamics based on the unloaded grinding gas flow and by observing the abrasion on the inner wall of the grinding chamber caused by the particle-loaded flow. Consequently, the experimental findings can be utilized to create a model of the deflected and deformed nozzle jet, thereby providing a profound understanding of the flow processes within a spiral jet mill, particularly in the region of the nozzle jets.