The hydrothermal method was successfully used in the current work to fabricate YCeO nanocomposites, a novel hydrogen (H2) gas sensor. XRD, FE-SEM, and AFM were performed to determine the crystal structure and morphology of as prepared nanocomposite. The cubic structure of space group Fm3m with a density of 6.74 gmcm−3, a volume of 157.81 106 pm3, and a crystallite size of 18.66 nm is obtained in the XRD pattern of YCeO in this instance. Furthermore, the granular structure and roughness of the surface can be seen in FE-SEM and AFM studies. Additionally, hydrogen sensing was performed at a temperature of 28 °C with a hydrogen concentration of 20–120 ppm. The sensor response for hydrogen gas at 20 and 120 ppm was measured to be 1.41 and 2.09, respectively. At 20 ppm, we came to know that the recovery times and rapid response were 75.54 s and 40.81 s, respectively. The long-term stability was also checked for 40 days and the change in sensor response at 20 and 40 days was 1.40 and 1.39, respectively. The investigated sensor device also demonstrates the benefits of a straightforward fabrication procedure, a basic structure, and a very affordable hydrogen detection sensor.
Nano-sensors samples of pure Zinc oxide and tungsten doped ZnO are employed for the study of their humidity sensing performance, morphological and micro-structural details. The nano-powder for sensors of ZnO1 − xWx (x = 0 to 1.75 mol%) are prepared in molar ratios of 0.50 mol%, 1.25 mol%, and 1.75mol% synthesized through co-precipitation technique. The effect of tungsten incorporation in 0.50 mol%, 1.25 mol% and 1.75 mol% on the structural and morphological properties of nanostructures has been investigated via XRD and SEM, respectively. The XRD of the synthesized ZnO nanomaterial possess hexagonal wurtzite structure for all the samples. The obtained diffractogram depicts high and broad peaks implying good crystallinity and smaller crystallite size. The molarity of the dopants yields sufficient reduction in crystallite size from 44.46 nm to 37.38 nm. The crystallite size of the samples calculated using W-H analysis yields 44.28 nm to 39.37 nm. The strain (ϵ) and stress (σ) produced in the crystal due to dopants is analyzed via USDM, UDEDM and SSP thereby deducing energy density ‘u’. The pelletized nano-sensors of diameter 10 mm and thickness 2 mm show excellent response towards humidity sensing within the range of 10–90% of relative humidity. An appreciable sensitivity of 144x and hysteresis of 8.24 is exhibited 1.75 mol% W-ZnO humidity sensor and good stability over a period of 270 days with minimum aging effects.