Jing Song

Dr. Jing Song


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 February 2023 in Materials
Verified
Journal Article
Open access
PDF file
YLYunpeng Li
Yunpeng Li
HSHongqian Sun
Hongqian Sun
JSJing Song
Jing Song
ZZZhiyu Zhang
Zhiyu Zhang
Hao LanHao Lan
Hao Lan
KXKeqiang Xie
Keqiang Xie
Yttria-stabilized zirconia (YSZ) has been widely used in structural and functional ceramics because of its excellent physicochemical properties. In this paper, the density, average gain size, phase structure, and mechanical and electrical properties of conventionally sintered (CS) and two-step sintered (TSS) 5YSZ and 8YSZ are investigated in detail. As the grain size of YSZ ceramics became smaller, dense YSZ materials with a submicron grain size and low sintering temperature were optimized in terms of their mechanical and electrical properties. 5YSZ and 8YSZ in the TSS process significantly improved the plasticity, toughness, and electrical conductivity of the samples and significantly suppressed the rapid grain growth. The experimental results showed that the hardness of the samples was mainly affected by the volume density, that the maximum fracture toughness of 5YSZ increased from 3.514 MPa·m1/2 to 4.034 MPa·m1/2 in the TSS process, an increase of 14.8%, and that the maximum fracture toughness of 8YSZ increased from 1.491 MPa·m1/2 to 2.126 MPa·m1/2, an increase of 42.58%. The maximum total conductivity of the 5YSZ and 8YSZ samples under 680 °C increased from 3.52 × 10−3 S/cm and 6.09 × 10−3 S/cm to 4.52 × 10−3 S/cm and 7.87 × 10−3 S/cm, an increase of 28.41% and 29.22%, respectively.

26 May 2024 in Metals
Verified
Journal Article
Open access
PDF file
HSHongqian Sun
Hongqian Sun
JSJing Song
Jing Song
TQTao Qi
Tao Qi
In order to cleanly and efficiently extract zirconium from zircon sand (the main component is ZrSiO4), sodium hydroxide sub-molten salt was used to decompose ZrSiO4 in this study. When ZrSiO4 reacts with sodium hydroxide sub-molten salt, the formation of Na2ZrSiO5 (a water-insoluble product) considerably affects the separation efficiency of Zr and Si and increases production cost. Thus, it is necessary to control the formation of Na2ZrSiO5. The influence of NaOH content, reaction temperature, reaction time, and NaOH/ore mass ratio on the formation of Na2ZrSiO5 were systematically investigated. The optimum reaction parameters for the inhibition of Na2ZrSiO5 formation were as follows: 80% NaOH content, 245 °C reaction temperature, 4:1 NaOH/ore mass ratio, 10 h reaction time, and 400 r/min agitation speed. These results indicate that ZrSiO4 is decomposed to Na2ZrO3 and Na2SiO3 by reacting with NaOH, realizing the separation of Zr and Si, and then the reactions between Na2ZrO3 and Na2SiO3 result in the formation of Na2ZrSiO5, during the decomposition of ZrSiO4 using NaOH sub-molten salt. The sub-molten salt decomposition process can realize the clean extraction of zirconium, which is conducive to the sustainable development of zirconium resources.

1 July 2024 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
HSHongqian Sun
Hongqian Sun
JSJing Song
Jing Song
PSPengfei Shi
Pengfei Shi
ZCZhenqian Cheng
Zhenqian Cheng
LTLiang Liang Tian
Liang Liang Tian
TQTao Qi
Tao Qi
An yttrium-stabilized zirconia-based electrochemical sensor with LaCrO 3 as the electrode material was used to selectively detect NO.

1 May 2023 in Journal of the Electrochemical Society
Verified
Journal Article
Closed access
HSHongqian Sun
Hongqian Sun
YLYunpeng Li
Yunpeng Li
ZZZhiyu Zhang
Zhiyu Zhang
JSJing Song
Jing Song
LTLiangliang Tian
Liangliang Tian
TQTao Qi
Tao Qi
This study presents the preparation of a nitrogen dioxide (NO2) gas sensor based on yttrium-stabilized zirconia (YSZ) using a hard-template method and evaporation self-assembly technology. The sensing electrode employed is nickel oxide, and the sensor exhibits an efficient three-phase boundary. The study systematically investigates the effects of changing the three-phase reaction boundary on the gas-sensing performance of the sensor. A three-dimensional (3D) ordered macroporous (3DOM) structure was deposited on a YSZ substrate using the hard template method to obtain an efficient three-phase boundary. At 450 °C and 100 ppm NO2, the response value of the sensor with a 3D-ordered porous structure was 38.71 mV, which is 1.91 times the response value observed for the untreated YSZ-based sensor (20.3 mV), and the sensitivity significantly improved. In addition, a sensor with a 3D-ordered structure exhibits good 2 selectivity, and long-term stability. The improvement in the sensitivity of the sensor can be attributed to an increase in the area of the three-phase reaction boundary and an increase in the number of active sites in the electrochemical reaction.

11 October 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
XLXue Li
Xue Li
GHGege He
Gege He
CZChong Zeng
Chong Zeng
DZDengmei Zhou
Dengmei Zhou
JXJing Xiang
Jing Xiang
JSJing Song
Jing Song
Although sheet-like materials have good electrochemical properties, they still suffer from agglomeration problems during the electrocatalytic process. Integrating two-dimensional building blocks into a hollow cage-like structure is considered as an effective way to prevent agglomeration. In this work, the hierarchical NiCo2O4 nanocages were successfully synthesized via coordinated etching and precipitation method combined with a post-annealing process. The nanocages are constructed through the interaction of two-dimensional NiCo2O4 nanosheets, forming a three-dimensional hollow hierarchical architecture. The three-dimensional supporting cavity effectively prevents the aggregation of NiCo2O4 nanosheets and the hollow porous feature provides amounts of channels for mass transport and electron transfer. As an electrocatalytic electrode for methanol, the NiCo2O4 nanocages-modified glassy carbon electrode exhibits a lower overpotential of 0.29 V than those of NiO nanocages (0.38 V) and Co3O4 nanocages (0.34 V) modified glassy carbon electrodes. The low overpotential is attributed to the prominent electrocatalytic dynamic issued from the three-dimensional hollow porous architecture and two-dimensional hierarchical feature of NiCo2O4 building blocks. Furthermore, the hollow porous structure provides sufficient interspace for accommodation of structural strain and volume change, leading to improved cycling stability. The NiCo2O4 nanocages-modified glassy carbon electrode still maintains 80% of its original value after 1000 consecutive cycles. The results demonstrate that the NiCo2O4 nanocages could have potential applications in the field of direct methanol fuel cells due to the synergy between two-dimensional hierarchical feature and three-dimensional hollow structure.

22 April 2025 in Metals
Verified
Journal Article
Open access
PDF file
STShuo Tian
Shuo Tian
JSJing Song
Jing Song
HSHongqian Sun
Hongqian Sun
CZCongcong Zhao
Congcong Zhao
ZZZhiyu Zhang
Zhiyu Zhang
TQTao Qi
Tao Qi
Zirconium (Zr) and hafnium (Hf) are very important in nuclear and high-temperature applications, but their similar physical and chemical properties bring great challenges to separation. The current extraction methods have defects, such as low efficiency at high metal concentration. In this article, a zirconium (Zr)/hafnium (Hf) solvent extractive separation from sulfuric acid solutions using trioctylamine (TOA) as the extractant was researched at room temperature. The aqueous solution is prepared using zirconium sulfate (containing Hf), and the concentration of metal ions (Zr4+ and Hf4+) was about 1.096 mol·L−1. The effects of the aqueous acidity, the concentration of TOA, the contacting time, and the organic to aqueous O/A ratio on the separation of Zr and Hf were investigated. It is observed that the Zr can be extracted in the organic phase selectively, and the optimal conditions were: TOA concentration of 40 vol%, organic to aqueous O/A ratio of 3, contacting time of 5 min. Under these conditions, the single-stage extraction rate of Zr is 61.23%, while the Hf is almost not extracted. The mechanism of Zr extraction by TOA was studied through the saturation capacity and slope methods. Based on the results, it is believed that the structure of the extracted complex may be [R3NH]2[Zr(SO4)3]. This study provides a new approach for the development of industrialized Zr-Hf separation.