Microbial fuel cells (MFCs) provide new opportunities for the sustainable production of energy, converting organic matter into electricity through microorganisms. Moreover, MFCs play an important role in remediation of environmental pollutants from wastewater with power generation. This work focuses on the evaluation of ferroelectric perovskite materials as a new class of non-precious photocatalysts for MFC cathode construction. Nanoparticles of BaTiO₃ (BT) were prepared and tested in a microbial fuel cell (MFC) as photocathode catalytic components. The catalyst phases were synthesized, identified and characterized by XRD, SEM, UV–Vis absorption spectroscopy, P-E hysteresis and dielectric measurements. The maximum absorption of BT nanoparticles was recorded at 285 nm and the energy gap (Eg) was estimated to be 3.77 eV. Photocatalytic performance of cathodes coated with BaTiO₃ was measured in a dark environment and then in the presence of a UV–visible (UV–Vis) light source, using a mixture of dairy industry and domestic wastewater as a feedstock for the MFCs. The performance of the BT cathodic component is strongly dependent on the presence of UV–Vis irradiation. The BT-based cathode functioning under UV–visible light improves the maximum power densities and the open circuit voltage (OCV) of the MFC system. The values increased from 64 mW m⁻² to 498 mW m⁻² and from 280 mV to 387 mV, respectively, showing that the presence of light effectively improved the photocatalytic activity of this ceramic. Furthermore, the MFCs operating under optimal conditions were able to reduce the chemical oxygen demand load in wastewater by 90% (initial COD = 2500 mg L⁻¹).

The depollution of constructed wetland-pretreated olive mill wastewater (OMW) using a membrane filtration system was experimentally studied. Dead-end filtration (DEF) was employed to evaluate suitable MF/UF membranes and select the appropriate molecular weight cut-off for optimal OMW treatment. Removal efficiencies for COD (chemical oxygen demand) and TOC (total organic carbon) using DEF reached maximum values of 88.14% and 11.17%, respectively. Adsorption of raw and pretreated OMW on granular activated carbon was also carried out for a comparative study against DEF and pretreatment. The semi-industrial-scale experiments were conducted using commercial ceramic ultrafiltration (UF) membranes (150 and 50 kDa) in cross-flow filtration (CFF) mode at a permeate flux around 200 L h⁻¹ m⁻² and a trans-membrane pressure (TMP) of 3.5–3.8 bars. This post-treatment had a significant impact on COD removal efficiency from pretreated OMW, reaching 78.5%. The coupled process proposed in this study achieved removal efficiencies of 97%, 97%, and 99.9% of COD, TOC, and turbidity, respectively.