A series-parallel model is introduced to calculate the effective thermal conductivities of hollow claddings of photonic crystal fibers (PCFs). The temperature distribution and thermal-optical properties of PCF lasers are studied by solving the heat transfer equations. The average power scaling of the PCF lasers in respect of the thermal effects is also discussed.
Optical Engineering (OE) publishes peer-reviewed papers reporting on research, development, and applications of optics, photonics, and imaging science and engineering.
<!-- *** Custom HTML *** --> To quantitatively analyze the influence of vehicle platform vibration on the vehicle laser radar (LIDAR) measurement accuracy, the modal, harmonic response, and random vibration are analyzed using finite-element software. On this basis, combined with the optical path structure of LIDAR, the deformation of mirror caused by vibration is analyzed. The results show that the maximum deflection of the laser output angle resulting from the mirror deformation is about 0.0001 deg, which is much less than the 0.00573 deg (0.1 mrad) that is required by the performance of the vehicle LIDAR.
Using the finite element method and the heat conduction equation, the temperature, stress, and end-face deformation in Tm:YAP crystal under high pump power were analyzed. Combined with gradient doping technology, an effective way to improve the internal heat distribution of the crystal was studied. The results showed that when the total pump power was 200 W, under the same cooling conditions, the maximum temperature difference inside Tm:YAP decreased from 58 K to 25 K after gradient doping. The thermal stress and end-face thermal deformation were also significantly improved. In addition, a reasonable micro-channel structure also effectively removed the heat generated inside the crystal.
To address the challenge of laser beam distortion induced by thermal effects in high-power slab laser amplifiers, a coupled thermal–mechanical–optical model for a face-pumped Yb:YAG multi-pass amplifier was developed. The thermal effects under different thermal management strategies were systematically investigated using the finite element method. Firstly, the temperature distribution, thermal stress, and deformation within the Yb:YAG crystal were analyzed and compared under both room-temperature (293 K) and cryogenic (150 K) cooling conditions using a microchannel cooling structure. The results demonstrate that under a pump power of 100 W and room-temperature cooling, the peak temperature of the gain medium reaches 363 K, with a peak thermal stress of 1.04 MPa and a maximum thermal deformation of 1.44 μm. In contrast, under cryogenic cooling at 150 K, the maximum temperature is reduced to 188 K, and both thermal stress and deformation exhibit a more uniform distribution within the pumped region. Subsequently, the thermal lensing of bonded and non-bonded Yb:YAG crystals was compared and analyzed by ray-tracing. It was found that under a pump power of 100 W, the thermal focal lengths of non-bonded Yb:YAG are 1112 mm and 2559 mm at cooling temperatures of 293 K and 150 K, respectively. For bonded crystals with a 3 mm undoped YAG thickness under identical pumping and cooling conditions, the corresponding thermal focal lengths measure 1508 mm and 3044 mm. When the undoped YAG thickness increases to 6 mm, the thermal focal lengths further extend to 1789 mm and 4206 mm, respectively.
Heat conduction, temperature distribution, thermal stress, and thermally induced refractive index of a diode-pumped active-mirror grad-doped Yb:YAG ceramic laser are analyzed and compared to a uniform-doped Yb:YAG ceramic laser. It is found that a rationally designed grad-doped Yb:YAG ceramic has a smaller temperature gradient than a uniform-doped Yb:YAG ceramic with the same absorption pump power, which results in higher output energy in the grad-doped Yb:YAG ceramic laser.