In order to address the issue of thermal damage induced by laser processing of carbon fiber reinforced polymer (CFRP), researchers have conducted an optimization study of process parameters in the laser processing of CFRP. Their aim is to elucidate the relationship between process parameters and processing quality to minimize thermal damage. However, during laser processing, there exists a complex nonlinear relationship between process parameters and processing quality, making it challenging to establish high-precision predictive models, while the intrinsic connection between these two aspects remains incompletely revealed. In light of this, this study proposes utilization of machine learning techniques to explore the inherent relationship between process parameters and processing quality and establishes a 5-13-5 type back-propagation (BP) neural network predictive model. Subsequently, genetic algorithms are employed to optimize the weights and thresholds of the BP neural network, and the model is then subjected to validation. The results indicate that the BP neural network predictive model yields average errors of 5% for surface heat-affected zone (HAZ), 2.9% for groove width, 5.9% for cross-sectional HAZ, 1.8% for groove depth, and 4.5% for aspect ratio, demonstrating a relatively high level of accuracy but with notable fluctuations. The GA-BP model, when predicting the surface HAZ and the groove width, achieves errors of 4.5% and 2.7%, respectively, which are lower when compared to the BP model, indicating a higher predictive accuracy. The GA-BP model established in this study unveils the intrinsic connection between process parameters and processing quality, providing a novel means for an effective quality prediction in the processing of CFRP.
In water-guided laser technology, the stability of water jets is crucial to ensure the efficient transmission of laser energy. However, the thermal effects generated when high-power lasers are coupled with water jets are bound to impact the stability of the water jets, thus becoming a critical issue that restricts the development of high-power water-guided laser technology. In addressing this issue, this paper establishes a temperature model for coupling high-power lasers with water jets. Subsequently, with validation of the model's effectiveness through experimental data, simulations are conducted to analyze the temperature distribution within the water jet. During the simulation process, lasers with different parameters were coupled with water jets to analyze the temperature variation law of the water jets. Additionally, the maximum laser power coupled with water jets of different lengths was solved. Based on the calculated temperature values of the water jet, simulate the evolution of its profile over time when it has an initial temperature gradient. Simultaneously, perform a three-dimensional reconstruction of the obtained perturbed profile and conduct ray tracing to analyze the laser's transmission losses within the perturbed profile. Finally, high-speed cameras are utilized to capture the profile of the water jet, validating the laser-induced fragmentation behavior in the water jet. The research findings will provide a significant reference value for selecting laser parameters and controlling thermal effects in water-guided high-power technology.