Three different forms of Cu powder particles obtained by either galvanostatic electrolysis or a non-electrolytic method were analyzed by a scanning electron microscope (SEM), X-ray diffraction (XRD) and particle size distribution (PSD). Electrolytic procedures were performed under different hydrogen evolution conditions, leading to the formation of either 3D branched dendrites or disperse cauliflower-like particles. The third type of particles were compact agglomerates of the Cu grains, whose structural characteristics indicated that they were formed by a non-electrolytic method. Unlike the sharp tips that characterize the usual form of Cu dendrites, the ends of both the trunk and branches were globules in the formed dendrites, indicating that a novel type of Cu dendrites was formed in this investigation. Although the macro structures of the particles were extremely varied, they had very similar micro structures because they were constructed by spherical grains. The Cu crystallites were randomly oriented in the dendrites and compact agglomerates of the Cu grains, while the disperse cauliflower-like particles showed (220) and (311) preferred orientation. This indicates that the applied current density affects not only the morphology of the particles, but also their crystal structure. The best performance, defined by the largest specific surface area and the smallest particle size, was by the galvanostatically produced powder consisting of disperse cauliflower-like particles.
4 February 2009 in Journal of Thermal Analysis and Calorimetry
Composites for efficient removal of hexavalent chromium Cr(VI) from industrial wastewater were obtained by deposition of nano-zero-valent iron (nZVI), synthesized by environmentally friendly synthesis using oak leaf extract, on inexpensive, natural, readily available and cheap natural raw materials, sepiolite (SEP) or kaolinite/illite (KUb) clay, as support. nZVI particles were deposited from the FeCl3 solution of different concentrations, with the same volume ratio extract/FeCl3 solution (3:1), and with different masses of SEP or KUb. Physico–chemical characterization (SEM/EDS, FTIR, BET, determination of point of zero charge) of the composites and nZVI was performed. The results of SEM and BET analyses suggested more homogeneous deposition of nZVI onto SEP than onto KUb, which ensures greater availability of the nZVI surface for Cr(VI) anions. Therefore, the higher Cr(VI) removal at all investigated initial pH values (pHi) of the solution (3, 4 and 5) was achieved with the SEP composites. The adsorption results indicated that the elimination of Cr(VI) was achieved via the combined effect of reduction and adsorption. The removal of total chromium at pHi = 3 was approximately the same as that of Cr(VI) removal for the KUb composites, but lower for the SEP composites, indicating lower removal of Cr(III) compared to the reduced Cr(VI). The SEP/nZVI composite with the highest removal efficiency was applied for Cr(VI) removal from real wastewater at pHi = 3 and pHi = 5. The results demonstrated the high Cr(VI) removal capacity, validated the assumption that a good dispersion of nZVI particles is beneficial for Cr(VI) removal and showed that the produced green composites can be efficient materials for the removal of Cr(VI) from wastewater.
In this paper the results of the investigated properties of fly ash from four thermal power plants in Serbia are presented. The physical, chemical, mineralogical and thermal characterization of fly ash was carried out, in order to determine the possibility to utilize this material in the building materials industry, foremost in the cement industry. It was determined that, although there are differences concerning the physical, chemical, and mineralogical characteristics of the investigated samples, they are very similar concerning their thermal characteristics. It was concluded that using fly ash as one of the raw components in the mixture for Portland cement clinker synthesis, not only enables the substitution of natural resources, but it might have a positive effect on the lowering of the sintering temperature.