The study investigated the use of CeO2 extracted from monazite with calcium oxide (CaO) as a solid catalyst for biodiesel production. The wet impregnation method was used to produce CaO@CeO2 mixed-oxide catalysts with 0–50 wt.% CaO. X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) surface area analysis, thermogravimetric analysis (TGA), and a Fourier transform infrared spectrometer (FTIR) was used to characterize the catalysts. In order to determine the optimal preparation conditions, the effect of different CaO compositions on the performance of CaO@CeO2 mixed-oxide catalysts was examined. The catalytic activity of the CaO@CeO2 catalyst for the transesterification reaction of palm oil to produce biodiesel was studied. The results show that the optimum yield of biodiesel can reach 97% fatty acid methyl ester over the 30CaO@CeO2 catalyst at the reaction conditions of 5 wt.% catalysts, methanol-to-oil molar ratio of 9:1, with a reaction temperature of 65 °C within 30 min. The results show that the high catalytic activity and stability of the CaO@CeO2 catalyst make it a promising candidate for industrial-scale biodiesel production. Further study is needed to improve the stability and efficiency of catalysts in transesterification reactions to achieve a high FAME yield using long-life-span catalysts. Moreover, it is necessary to investigate the economic feasibility of this process for application in large-scale biodiesel production.
This study reports the mass concentrations, elemental characterization and identification of the possible sources of PM2.5 and PM10 at a suburban site in Pathum Thani, Thailand. The sampling was done from 18 February 2021 to 14 September 2021. PM2.5 concentrations were between 0.39 μg/m3 and 174.26 μg/m3, while PM10 concentration ranged from 12.75 μg/m3 to 242.02 μg/m3. The average concentration of PM2.5 in the wet season (61.96 μg/m3) in the study area exceeded the national ambient air quality standards (NAAQS). Particle-induced X-ray emission (PIXE) was used to measure the element concentrations. The main elements, namely Fe, K, Cr and Ca, in both PM2.5 and PM10 showed significantly higher concentrations in the summer season. A qualitative inter-elemental correlation analysis, principal component analysis (PCA) and cluster analysis (CA) were applied for source identification of PM2.5 and PM10. The results for the three procedures were in good agreement. Four and three factors of sources were isolated by the PCA for PM2.5 and PM10, respectively. The main sources identified by PCA were, for PM2.5, soil dust and biomass burning (32%), road dust and industrial emission (25%), vehicle and industrial emission (10%) and soil dust (9%); for PM10, road dust and industrial emission (36%), crustal and biomass burning (30%) and industrial sources (10%).
17 December 2018 in Journal of Physics: Conference Series
The Thai domestic rare earth oxides, including cerium, lanthanum, and neodymium oxides, with the effects of calcination temperatures (500–1000 °C), were utilized as catalysts for twelve Jatropha biodiesel alternatives via an esterification reaction. This study applied life cycle assessment (LCA) methodology from well-to-wheel analysis to assess energy efficiency and the global warming impact with and without land use change. The results of the life cycle analysis showed that the Jatropha biodiesel alternatives using the La2O3 catalyst in all conditions (0.89–1.06) were found to be potential fuel substitutes for conventional diesel (0.86) in terms of net energy ratios; however, the results showed that they generated a higher global warming impact. Considering the improvement process of Jatropha biodiesel in the utilization of waste heat recovery, the Jatropha biodiesel reduced the impacts of the net energy ratios and the global warming impact by 22–24% and 34–36%, respectively. The alternative Jatropha biodiesel using the La2O3 catalyst with a calcination temperature of 600 °C was shown to be the most environmentally friendly of all the studied fuels; relatively, it had the highest energy ratios of 1.06–1.37 (with and without waste heat recovery) and the lowest total global warming impact of 47.9–70.7 kg CO2 equivalent (with land use change). The integration of the material and process development by domestic catalysts and the recovery of waste heat would improve the sustainability choices of biofuel production from renewable resources for transportation fuels in Thailand.
10 February 2023 in Journal of Radioanalytical and Nuclear Chemistry
The possibility of the determination of U and Th concentration in the Thai monazite ore processing samples using gamma-ray spectrometry technique was investigated. The studied samples were monazite ore, tri-sodium phosphate, mixed rare earth hydroxide, enriched cerium, uranium cake, thorium cake, La2O3 and CeO2. The measured activity concentrations of 238U and 232Th were converted into the concentrations of U and Th under the assumption of secular equilibrium. The results showed that the major daughter nuclides found in the studied samples, were 214Pb 214Bi and 226Ra for 238U series with additional radionuclides of 228Ac, 212Pb, 208Tl and 212Bi for 232Th series. The concentrations of U and Th estimated via each daughter products of their series were not significantly different for all samples. Wavelength Dispersive X-ray Fluorescence (WDXRF) with different sample preparations (loose powder, pressed pellet and fused bead methods) was also used to determine the concentrations of both U and Th in these samples. A good agreement between the concentration of U and Th measured by gamma-ray spectrometry (U = 0.42 wt%, Th = 6.54) and WDXRF prepared by fused bead method (U = 0.41 wt%, Th = 7.37) was observed for monazite ore sample.