Models are necessary tools for watershed management. However, applying watershed models is time consuming and requires technical knowledge, including model selection and validation. The objective of this study is to assess two commonly used watershed models and their parameter sensitivity to reduce model loadings and to gain a better understanding of the model performances. The Hydrological Simulation Program-Fortran (HSPF) model and Storm Water Management Model (SWMM) were applied to a mostly forested Taiwanese reservoir watershed with pollution from tea plantations. Statistical analysis showed that both models are suitable for the studied watershed, but the performances of the flow and water quality simulations are different. The mean flow simulated by SWMM was lower than the experimental observations. The HSPF model performed better, possibly because the soil in the study area is highly permeable and the HSPF model has more precise soil layer calculations. SWMM may underestimate the total phosphorous (TP) and suspended solid (SS) loads following small storm events in highly permeable watersheds. The Latin Hypercube-One factor At a Time (LH-OAT) method was used to determine the parameter sensitivity of the HSPF model and SWMM. In both of the models, the parameters related to infiltration and soil characteristics strongly affected the flow simulation, except when using the Horton infiltration method in the SWMM. Manning’s roughness coefficient for pervious areas was more sensitive in SWMM than in the HSPF model because SWMM has fewer parameters.
Total maximum daily loads (TMDLs) are used to protect water bodies based on their assimilative ability and are transferred as a maximum allowable load, which is the sum of all pollution emissions in a watershed that cannot be exceeded. This allowable load is calculated from a target water quality concentration and a flow state. The target water quality concentration is typically consistent with water quality standards; however, it is difficult to determine which flow state to use, especially for lakes and reservoirs. In this study, an exceedance probability method is established for determining the TMDL for reservoirs. The SWMM (Storm Water Management Model) was used to understand the pollution loads from the watershed, and the Vollenweider model was used to simulate the total phosphorous (TP) concentrations in the reservoir. Using the validated Vollenweider model, the relationship between pollution loads and the target TP concentration is illustrated. This relationship is associated with real changes in the reservoir water volume and is presented as the exceedance probability. In the study area (i.e., the Shiman Reservoir in Taiwan), an exceedance probability of 50% is suggested, and the allowable TP load is 22,209 kg/year when considering a target TP concentration of 20 μg/L. When considering effective management, the pollution sources in three hot spots are priorities, and controlling their point and nonpoint pollution sources can decrease TP from 25 to 22 μg/L.