We use open-ended chains of oscillators, like those introduced by Fermi, Pasta, and Ulam, to mimic thermomechanical properties of crystalline solids, such as thermal expansion and the change of elasticity and quality factors with temperature. We employ molecular dynamics and theoretical arguments, separately. Features of real solids are reproduced, such as the positiveness of the coefficient of thermal expansion and the decrease of the modulus of elasticity and of the quality factor with temperature. The results depend strongly on the interparticle potential at energy levels much higher than the average energy of the chain, with the Lennard-Jones potential yielding the most realistic cases.
We derive the quantum analogues of some recently discovered symmetry relations for time correlation functions in systems subject to a constant magnetic field. The symmetry relations deal with the effect of time reversal and do not require—as in the formulations of Casimir and Kubo—that the magnetic field be reversed. It has been anticipated that the same symmetry relations hold for quantum systems. Thus, here we explicitly construct the required symmetry transformations, acting upon the relevant quantum operators, which conserve the Hamiltonian of a system of many interacting spinless particles, under time reversal. Differently from the classical case, parity transformations always reverse the sign of both the coordinates and of the momenta, while time reversal only of the latter. By implementing time reversal in conjunction with ad hoc “incomplete” parity transformations (i.e., transformations that act upon only some of the spatial directions), it is nevertheless possible to achieve the construction of the quantum analogues of the classical maps. The proof that the mentioned symmetry relations apply straightforwardly to quantal time correlation functions is outlined.
From basic principles, we review some fundamentals of entropy calculations, some of which are implicit in the literature. We mainly deal with microcanonical ensembles to effectively compare the counting of states in continuous and discrete settings. When dealing with non-interacting elements, this effectively reduces the calculation of the microcanonical entropy to counting the number of certain partitions, or compositions of a number. This is true in the literal sense, when quantization is assumed, even in the classical limit. Thus, we build on a moderately dated, ingenuous mathematical work of Haselgrove and Temperley on counting the partitions of an arbitrarily large positive integer into a fixed (but still large) number of summands, and show that it allows us to exactly calculate the low energy/temperature entropy of a one-dimensional Bose–Einstein gas in a box. Next, aided by the asymptotic analysis of the number of compositions of an integer as the sum of three squares, we estimate the entropy of the three-dimensional problem. For each selection of the total energy, there is a very sharp optimal number of particles to realize that energy. Therefore, the entropy is ‘large’ and almost independent of the particles, when the particles exceed that number. This number scales as the energy to the power of -rds in one dimension, and -ths in three dimensions. In the one-dimensional case, the threshold approaches zero temperature in the thermodynamic limit, but it is finite for mesoscopic systems. Below that value, we studied the intermediate stage, before the number of particles becomes a strong limiting factor for entropy optimization. We apply the results of moments of partitions of Coons and Kirsten to calculate the relative fluctuations of the ground state and excited states occupation numbers. At much lower temperatures than threshold, they vanish in all dimensions. We briefly review some of the same results in the grand canonical ensemble to show to what extents they differ.
We review two well-known definitions present in the literature, which are used to define the heat or energy flux in one dimensional chains. One definition equates the energy variation per particle to a discretized flux difference, which we here show it also corresponds to the flux of energy in the zero wavenumber limit in Fourier space, concurrently providing a general formula valid for all wavelengths. The other relies somewhat elaborately on a definition of the flux, which is a function of every coordinate in the line. We try to shed further light on their significance by introducing a novel integral operator, acting over movable boundaries represented by the neighboring particles’ positions, or some combinations thereof. By specializing to the case of chains with the particles’ order conserved, we show that the first definition corresponds to applying the differential continuity-equation operator after the application of the integral operator. Conversely, the second definition corresponds to applying the introduced integral operator to the energy flux. It is, therefore, an integral quantity and not a local quantity. More worryingly, it does not satisfy in any obvious way an equation of continuity. We show that in stationary states, the first definition is resilient to several formally legitimate modifications of the (models of) energy density distribution, while the second is not. On the other hand, it seems peculiar that this integral definition appears to capture a transport contribution, which may be called of convective nature, which is altogether missed by the former definition. In an attempt to connect the dots, we propose that the locally integrated flux divided by the inter-particle distance is a good measure of the energy flux. We show that the proposition can be explicitly constructed analytically by an ad hoc modification of the chosen model for the energy density.