The use of low-temperature (LT) GaAs layers as dislocation filters in GaAs/Si heterostructures (HSs) was investigated in this study. The effects of intermediate LT-GaAs layers and of the post-growth and cyclic in situ annealing on the structural properties of GaAs/LT-GaAs/GaAs/Si(001) HSs were studied. It was found that the introduction of LT-GaAs layers, in combination with post-growth cyclic annealing, reduced the threading dislocation density down to 5 × 106 cm−2, the root-mean-square roughness of the GaAs surface down to 1.1 nm, and the concentration of non-radiative recombination centers in the near-surface GaAs/Si regions down to the homoepitaxial GaAs level. Possible reasons for the improvement in the quality of near-surface GaAs layers are discussed. On the one hand, the presence of elastic deformations in the GaAs/LT-GaAs system led to dislocation line bending. On the other hand, gallium vacancies, formed in the LT-GaAs layers, diffused into the overlying GaAs layers and led to an increase in the dislocation glide rate. It was demonstrated that the GaAs/Si HSs obtained with these techniques are suitable for growing high-quality light-emitting HSs with self-assembled quantum dots.
In this work, the formation, structural properties, and energy spectrum of novel self-assembled GaSb/AlP quantum dots (SAQDs) were studied by experimental methods. The growth conditions for the SAQDs’ formation by molecular beam epitaxy on both matched GaP and artificial GaP/Si substrates were determined. An almost complete plastic relaxation of the elastic strain in SAQDs was reached. The strain relaxation in the SAQDs on the GaP/Si substrates does not lead to a reduction in the SAQDs luminescence efficiency, while the introduction of dislocations into SAQDs on the GaP substrates induced a strong quenching of SAQDs luminescence. Probably, this difference is caused by the introduction of Lomer 90°-dislocations without uncompensated atomic bonds in GaP/Si-based SAQDs, while threading 60°-dislocations are introduced into GaP-based SAQDs. It was shown that GaP/Si-based SAQDs have an energy spectrum of type II with an indirect bandgap and the ground electronic state belonging to the X-valley of the AlP conduction band. The hole localization energy in these SAQDs was estimated equal to 1.65–1.70 eV. This fact allows us to predict the charge storage time in the SAQDs to be as long as >>10 years, and it makes GaSb/AlP SAQDs promising objects for creating universal memory cells.
The band structure of three-layer symmetric InAs/GaSb/InAs quantum wells confined between AlSb barriers is analyzed theoretically. It is shown that, depending on the thicknesses of the InAs and GaSb layers, a normal band structure, a gapless state with a Dirac cone at the center of the Brillouin zone, or inverted band structure (two-dimensional topological insulator) can be realized in this system. Measurements of the cyclotron resonance in structures with gapless band spectra carried out for different electron concentrations confirm the existence of massless Dirac fermions in InAs/GaSb/InAs quantum wells.
The effect of substrate temperature, As2 and P2 molecular flux densities, and growth rate on the composition of III-PxAs1 − x solid solution layers prepared by molecular beam epitaxy is experimentally investigated. Experimental data in a wide range of growth conditions are analyzed. The results obtained are presented in the form of a kinetic model for describing the process of formation of the composition in the Group V sublattice of the III-PxAs1 − x solid solution upon molecular beam epitaxy. The model can be used for choosing the growth conditions of the III-PxAs1 − x (001) solid-solution layers of a specified composition.
2 November 2015 in Journal of Physics: Conference Series
The influence of As molecular form on the composition and crystalline properties of InAsxSb1-x solid solutions with MBE has been experimentally investigated. A series of samples has been grown at different growth temperatures. The grown samples were studied with the HRXRD and TEM methods. The incorporation coefficient of As4 and As2 molecules were determined at different growth temperatures. It has been found that the incorporation coefficient of As4 much more dependent on growth temperature compared to As2. It has been found that at a low growth temperature a step-like increase of Sb fraction in an InAsxSb1-x film leads to a decrease of threading dislocations density in a layer with a smaller x.
During the self-catalyzed GaAs nanowire growth formation of parasitic GaAs crystallites is observed. The reasons for crystallite formation are explained on the base of Monte Carlo simulation results. During simultaneous deposition of gallium and arsenic on the GaAs(111)B substrate coated by a silicon oxide film, liquid gallium droplets nucleate on the oxide surface. After nucleation, droplets enlarge in size with time and etch the oxide layer. Formation of GaAs crystal structures becomes possible only after the Ga droplet contacts underlying crystal substrate. It is shown that excessively high arsenic and gallium deposition rates lead to the crystallite formation at the initial growth stage. The GaAs crystallites collect part of the deposited gallium and arsenic decreasing their surface concentration, thereby, adjusting the growth conditions for the nanowire growth. Therefore, during the self-catalyzed GaAs nanowire growth the self-regulation of growth conditions takes place.