Tariq Rafiq

Prof. Dr. Tariq Rafiq

Department of Mechanical Engineering and Mechanics, Lehigh University, Bethlehem, PA 18015, USA
orcid

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 May 2010 in Nuclear Fusion
Verified
Journal Article
Closed access
JCJ.D. Callen
J.D. Callen
RGR.J. Groebner
R.J. Groebner
TOT.H. Osborne
T.H. Osborne
JCJ.M. Canik
J.M. Canik
LOL.W. Owen.
L.W. Owen.
WSW.M. Stacey
W.M. Stacey
An H-mode edge pedestal plasma transport benchmarking exercise was undertaken for a single DIII-D pedestal. Transport modelling codes used include 1.5D interpretive (ONETWO, GTEDGE), 1.5D predictive (ASTRA) and 2D ones (SOLPS, UEDGE). The particular DIII-D discharge considered is 98889, which has a typical low density pedestal. Profiles for the edge plasma are obtained from Thomson and charge-exchange recombination data averaged over the last 20% of the average 33.53 ms repetition time between type I edge localized modes. The modelled density of recycled neutrals is largest in the divertor X-point region and causes the edge plasma source rate to vary by a factor ∼102 on the separatrix. Modelled poloidal variations in the densities and temperatures on flux surfaces are small on all flux surfaces up to within about 2.6 mm (ρN > 0.99) of the mid-plane separatrix. For the assumed Fick's-diffusion-type laws, the radial heat and density fluxes vary poloidally by factors of 2–3 in the pedestal region; they are largest on the outboard mid-plane where flux surfaces are compressed and local radial gradients are largest. Convective heat flows are found to be small fractions of the electron (≲10%) and ion (≲25%) heat flows in this pedestal. Appropriately averaging the transport fluxes yields interpretive 1.5D effective diffusivities that are smallest near the mid-point of the pedestal. Their ‘transport barrier’ minima are about 0.3 (electron heat), 0.15 (ion heat) and 0.035 (density) m2 s−1. Electron heat transport is found to be best characterized by electron-temperature-gradient-induced transport at the pedestal top and paleoclassical transport throughout the pedestal. The effective ion heat diffusivity in the pedestal has a different profile from the neoclassical prediction and may be smaller than it. The very small effective density diffusivity may be the result of an inward pinch flow nearly balancing a diffusive outward radial density flux. The inward ion pinch velocity and density diffusion coefficient are determined by a new interpretive analysis technique that uses information from the force balance (momentum conservation) equations; the paleoclassical transport model provides a plausible explanation of these new results. Finally, the measurements and additional modelling needed to facilitate better pedestal plasma transport modelling are discussed.

1 March 2013 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
TRTariq Rafiq
Tariq Rafiq
AKA. H. Kritz
A. H. Kritz
JWJ. Weiland
J. Weiland
APA. Y. Pankin
A. Y. Pankin
LLL. Luo
L. Luo
The derivation of Multi-Mode anomalous transport module version 8.1 (MMM8.1) is presented. The MMM8.1 module is advanced, relative to MMM7.1, by the inclusion of peeling modes, dependence of turbulence correlation length on flow shear, electromagnetic effects in the toroidal momentum diffusivity, and the option to compute poloidal momentum diffusivity. The MMM8.1 model includes a model for ion temperature gradient, trapped electron, kinetic ballooning, peeling, collisionless and collision dominated magnetohydrodynamics modes as well as model for electron temperature gradient modes, and a model for drift resistive inertial ballooning modes. In the derivation of the MMM8.1 module, effects of collisions, fast ion and impurity dilution, non-circular flux surfaces, finite beta, and Shafranov shift are included. The MMM8.1 is used to compute thermal, particle, toroidal, and poloidal angular momentum transports. The fluid approach which underlies the derivation of MMM8.1 is expected to reliably predict, on an energy transport time scale, the evolution of temperature, density, and momentum profiles in plasma discharges for a wide range of plasma conditions.

15 August 2024 in Nuclear Fusion
Verified
Journal Article
Open access
JBJ.W. Berkery
J.W. Berkery
PAP.O. Adebayo-Ige
P.O. Adebayo-Ige
HKH. Al Khawaldeh
H. Al Khawaldeh
GAG. Avdeeva
G. Avdeeva
SBS-G. Baek
S-G. Baek
SZS. Zweben
S. Zweben
The objectives of NSTX-U research are to reinforce the advantages of STs while addressing the challenges. To extend confinement physics of low-A, high beta plasmas to lower collisionality levels, understanding of the transport mechanisms that set confinement performance and pedestal profiles is being advanced through gyrokinetic simulations, reduced model development, and comparison to NSTX experiment, as well as improved simulation of RF heating. To develop stable non-inductive scenarios needed for steady-state operation, various performance-limiting modes of instability were studied, including MHD, tearing modes, and energetic particle instabilities. Predictive tools were developed, covering disruptions, runaway electrons, equilibrium reconstruction, and control tools. To develop power and particle handling techniques to optimize plasma exhaust in high performance scenarios, innovative lithium-based solutions are being developed to handle the very high heat flux levels that the increased heating power and compact geometry of NSTX-U will produce, and will be seen in future STs. Predictive capabilities accounting for plasma phenomena, like edge harmonic oscillations, ELMs, and blobs, are being tested and improved. In these ways, NSTX-U researchers are advancing the physics understanding of ST plasmas to maximize the benefit that will be gained from further NSTX-U experiments and to increase confidence in projections to future devices.

1 June 2016 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
TRTariq Rafiq
Tariq Rafiq
JWJ. Weiland
J. Weiland
AKA. H. Kritz
A. H. Kritz
LLL. Luo
L. Luo
APA. Y. Pankin
A. Y. Pankin
Microtearing modes (MTMs) have been identified as a source of significant electron thermal transport in tokamak discharges. In order to describe the evolution of these discharges, it is necessary to improve the prediction of electron thermal transport. This can be accomplished by utilizing a model for transport driven by MTMs in whole device predictive modeling codes. The objective of this paper is to develop the dispersion relation that governs the MTM driven transport. A unified fluid/kinetic approach is used in the development of a nonlinear dispersion relation for MTMs. The derivation includes the effects of electrostatic and magnetic fluctuations, arbitrary electron-ion collisionality, electron temperature and density gradients, magnetic curvature, and the effects associated with the parallel propagation vector. An iterative nonlinear approach is used to calculate the distribution function employed in obtaining the nonlinear parallel current and the nonlinear dispersion relation. The third order nonlinear effects in magnetic fluctuations are included, and the influence of third order effects on a multi-wave system is considered. An envelope equation for the nonlinear microtearing modes in the collision dominant limit is introduced in order to obtain the saturation level. In the limit that the mode amplitude does not vary along the field line, slab geometry, and strong collisionality, the fluid dispersion relation for nonlinear microtearing modes is found to agree with the kinetic dispersion relation.

1 August 2010 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
TRTariq Rafiq
Tariq Rafiq
GBG. Bateman
G. Bateman
AKA. H. Kritz
A. H. Kritz
APA. Y. Pankin
A. Y. Pankin
A new model is developed for transport driven by drift-resistive-inertial ballooning modes (DRIBMs) in axisymmetric tokamak plasmas. The model is derived using two-fluid reduced Braginskii equations in a generalized ŝ−α geometry. The unified theory includes diamagnetic effects, parallel electron and ion dynamics, electron inertia, magnetic perturbations, transverse particle diffusion, gyroviscous stress terms, electron and ion equilibrium temperature gradients, and temperature perturbations. A mixing length approximation is used to compute electron and ion thermal transport as well as particle fluxes from eigenvalues and eigenvectors of the linearized equations. The prediction for the saturation level is obtained by balancing the DRIBM growth rate against the nonlinear E×B convection. The parametric dependence of DRIBMs is investigated in systematic scans over density gradient, electron and ion temperature gradients, magnetic-q , collision frequency, magnetic shear, and Larmor radius. The DRIBM threshold is determined as a function of the collision frequency and the density and temperature gradients. The transition from DRIBM to the toroidal ion temperature gradient (ITG) mode is observed for small density gradients. For steep density gradients, the effect of ITG on DRIBM is found to be stabilizing. The transport seen in the DRIBM is of a scale that is consistent with the observed experimental anomalous transport, suggesting that the DRIBM mode could be the principle agent responsible for edge transport in Ohmic and L -mode discharges.

1 October 2001 in Physics of Plasmas
Verified
Journal Article
Closed access
MNM. Nadeem
M. Nadeem
TRTariq Rafiq
Tariq Rafiq
MPM. Persson
M. Persson
A study of the effect of local magnetic shear on the drift wave stability is presented. The eigenvalue problem for the drift wave equation is solved numerically in fully three-dimensional stellarator plasma using the ballooning mode formalism. It is found that negative local magnetic shear has a stabilizing effect on the drift wave instability and positive local shear is destabilizing. This is in agreement with the effect of negative global magnetic shear in tokamaks and also agrees with the simple estimates. As a consequence the highly unstable modes found on a specific magnetic surface are localized in the region of positive local magnetic shear.