The GRACE/GRACE-FO satellites have observed large scale mass changes, contributing to the mass budget calculation of the hydro-and cryosphere. The scale of the observable mass changes must be in the order of 300 km or bigger to be resolved. Smaller scale glaciers and hydrologic basins significantly contribute to the closure of the water mass balance, but are not detected with the present spatial resolution of the satellite. The challenge of future satellite gravity missions is to fill this gap, providing higher temporal and spatial resolution. We assess the impact of a geodetic satellite mission carrying on board a cold atom interferometric gradiometer (MOCASS: Mass Observation with Cold Atom Sensors in Space) on the resolution of simulated geophysical phenomena, considering mass changes in the hydrosphere and cryosphere. Moreover, we consider mass redistributions due to seamounts and tectonic movements, belonging to the solid earth processes. The MOCASS type satellite is able to recover 50% smaller deglaciation rates over a mountain range as the High Mountains of Asia compared to GRACE, and to detect the mass of 60% of the cumulative number of glaciers, an improvement respect to GRACE which detects less than 20% in the same area. For seamounts a significantly smaller mass eruption could be detected with respect to GRACE, reaching a level of mass detection of a submarine basalt eruption of 1.6 10⁹ m³. This mass corresponds to the eruption of Mount Saint Helens. The simulations demonstrate that a MOCASS type mission would significantly improve the resolution of mass changes respect to existing geodetic satellite missions.

Electrical resistivity tomography (ERT) is one of the most commonly used geophysical methods for imaging the distribution of electrical resistivity in the subsurface. It is often employed to characterise heterogeneity in karst regions and locate cavities and conduits below the surface. The resistivity contrast between the host rock and the cavity depends on the material filling the cavity. Air has a high electrical resistivity and should therefore produce strong reflections and refractions off cavity walls. However, cavities are not always easily detectable. A decrease in resistivity contrast at the interface between rock and air may result from different physical conditions relating to pore saturation, fracturing and stress near the cavity walls. Our first goal is to understand how extensive fracturing and hydrogeological conditions in the first subsurface layers can affect electric current flow in the presence of a karst tunnel. We use the commercial Res2Dmod software 3.0 to simulate an ERT on several ground models. The results, which are based on hydrogeological models, are presented for several conditions of a karst conduit: empty; full of water within a homogeneous background; and below the groundwater level in the presence of extensive fractures in the shallow layer above it.

The Castle of Melfi is placed on a hilltop overlooking the modern town and it includes many buildings that have been modified and expanded over time. Its Norman-era core was probably built between the end of the 11th and the start of the 12th century on top of an earlier Byzantine castrum; it was enlarged during the reign of Frederick II and additional alterations were undertaken during the reigns of the Angevin and Aragonese. Integrated ground-penetrating radar (GPR) and electrical resistivity tomography (ERT) surveys were carried out inside two courtyards of the westernmost part of the castle, the Cortile degli Armigeri and the Cortile del Mortorio, and in an external eastern wall area in order to identify ancient buried structures through two different methods of investigation and to compare the results.

An important geological risk to which many towns in Puglia are exposed is sinking cavities in urban areas. For urban centers, studying, mapping, providing geological and speleological descriptions, classifying, and cataloging the forms and types of cavities is essential because cavities are linked to past local anthropic and natural processes at different sites. These circumstances could lead to the enhancement of existing underground cavities in urban areas through conservation and continuous monitoring. Unfortunately, in many cases, these underground cavities have been used as landfills and subsequently abandoned. In late March 2007, one of these cavities collapsed inside Gallipoli’s inhabited center, causing damage to the structures but fortunately not human lives. In the area surrounding the collapsed cavity, a series of geophysical investigations were undertaken using ground penetrating radar in an attempt to delimit the area of collapse and develop possible interventions for restoration. In the same area, these measures were repeated 16 years later in December 2022 due to another collapse. The comparison between data acquired in these two periods shows that there were no strong changes apart from an increased presence of subsoil moisture in 2022.

We have developed a new method for the direct current resistivity interpretation, based on the continuous wavelet transform (CWT) of electric potential-difference data. It exploits the main properties of the CWT, such as stability versus noise, and does not require a starting model or other a priori information such as a model weighting function or constraints. Because the approximate integral equation of the resistivity problem has the same form as the forward problem for potential fields, the authors analyze geoelectric data (with dipole-dipole configuration) using the wavelets belonging to the Poisson kernel semigroup. They find that the CWT analysis of the measured electric potential difference is able to identify buried bodies, defining their depth, position, and extent. Such parameters are estimated with no prior knowledge of the resistivity contrast between the bodies and the background. We consider several synthetic models, such as dikes, compact bodies, and contacts. In general, the depth and the lateral thickness of the buried bodies are estimated with good accuracy, using a diagram relating the singular point estimations to the different values of the dipole separation factor n. Thanks to the good results obtained from synthetic data, we test the method with data generated during laboratory experiments. In two laboratory-scale models, our method displays a better precision compared with smoothness-constrained least-squares inversion in identifying the exact position of the edges of a buried body. Finally, we find that combining CWT and inversion is advantageous: after constraining the inverse problem with a priori information from the CWT analysis, we obtain an improved inverse model.